Skip to the record
The only place to find full transcripts.

Council archive · source document

planning report 98 Hilton · MCU26/0078

of 9

Text shows just the words. Original shows the document exactly as it was published.

5.1.2 State Planning Policy

The SPP includes assessment benchmarks that may be applicable where a local government
planning scheme does not adequately reflect the SPP. The Noosa Plan 2020 appropriately
integrates all SPP provisions, except for Natural Hazards, risk and resilience – coastal hazards – in
part. The site is located within the Coastal Management District and erosion prone area, as shown
on the SPP interactive mapping system.

In accordance with Schedule 10, Part 17, Table 6 the application does not require referral as the
gross floor area is not increasing by 1,000m2 and work associated with the dwelling house is not
considered part of the building work, and not operational work. No referral is required and the design
is compliant with the SDAP State Code 8 provisions, with the redevelopment of an existing building
within the erosion prone area. The design includes a large setback to the Noosa River boundary
(9.2m to pool edge), and habitable floor levels above 2.7m AHD, which accounts for flood heights
that includes 2100 climate change conditions.




                        Figure 5: State Coastal Hazard Mapping (Source: QLD Government)




                                                                                           Page 8 of 9

Used in these records

About this file

File size
2.0 MB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

planning report 98 Hilton.pdf · 2.0 MB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.