Council archive · source document
Decision Notice - Approved by Delegation of Authority MCU26 0001 - AS PUBLISHED · MCU26/0001
DA6.01 F Renders prepared by Blackwood 28/07/2026
DA6.02 F Renders prepared by Blackwood 28/07/2026
Amendment 1 Revise plans illustrating a 1.5m side boundary setback to Unit 1 and
Unit 2, measured from the outer edge of the terrace balustrade to the
side boundary.
Amendment 2 Revise plans showing a screening device along Unit 3’s southern
terrace to filter overlooking opportunities between properties. The
screening device is not to extend the full length of the elevation and
must not result in a space contributing to gross floor area.
Amendment 3 Revise the plans to reduce the extent of built form on the rooftop
terrace by minimising the staircase structure and reducing the floor-
to-ceiling height to the minimum extent necessary, to the satisfaction
of Council.
*(Refer to Advisory Note)
Nature and Extent of Approved Use
5. The approved use is for the purpose of a Multiple dwelling development, consisting of 3 small
dwellings and 1 larger dwelling.
Building Height
6. The maximum height of the development must not exceed 12 metres above the ground level.
7. Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
certifies that the building does not exceed the maximum height requirement of this Decision
Notice.
Performance Bond
8. Security in the form of a cash bond or trading bank guarantee to the sum of $20,000 must
be submitted to Council, to secure performance of all conditions of this approval, prior to the
pre-start meeting. The cash bond or trading bank guarantee will be returned on performance
of the conditions of approval less any costs incurred by Council in respect of enforcing
performance of this permit. Council reserves the right to call upon the bond or guaranteed
sum to effect compliance with conditions.
Street Identification
9. The street address of the development must be clearly visible and discernible from the
primary frontage of the site by the provision of a street number and, where appropriate, the
building name.
Building Appearance
10. External design features, materials and finishes must be as shown on the Approved Plans
(refer to approved Materials and Finishes Palette), with no inclusions or alterations made
without approval in writing by Council.
11. External finishes of the building must be a mix of lightweight and textured external finishes,
with masonry areas incorporating a variety of textured finishes to break up the surface.
12. All deck and balcony areas must not be enclosed with shutters, louvres, glass panelling or
the like thus remaining as open structures, except where required to satisfy any privacy
condition of this Decision Notice.
13. Waste storage areas, clothes drying areas and external storage areas must be screened
from view of the street.
Page 3 of 19
Document Set ID: 25157850
Version: 2, Version Date: 10/09/2026
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Decision Notice - Approved by Delegation of Authority MCU26 0001 - AS PUBLISHEDRelated documentApplication case desk ↗
About this file
- File size
- 200 KB (small file)
- File type
No other editions are linked here.