Appendix B - Bushfire Hazard Assessment · RAL22/0006

2.0     BUSHFIRE HAZARD ASSESSMENT
2.1     STATE ASSESSMENT METHODOLOGY
2.1.1   General
The Noosa Plan 2020 requires a site-specific bushfire hazard assessment to be undertaken when a
development site is located within a mapped Bushfire Hazard Area. Chapter 2, Part 1, Section 8, Item 4(a)
of the Planning Act 2016 states that ‘where there is an inconsistency between a State Planning Policy and
a local government planning instrument, a State Planning Policy applies instead of a local planning
instrument’. The SPP mapping is therefore used as the trigger for assessment against Council’s Bushfire
Hazard Overlay. Furthermore, the site-specific hazard mapping required by the Planning Scheme is to be
prepared consistent with the methodology adopted to prepare the SPP mapping.

The State government have described the methodology used to prepare the SPP mapping in the following
publications:
     Natural Hazards, Risk and Resilience –– Bushfire State Planning Policy – state interest guidance
       material (The Department of Infrastructure, Local Government and Planning, 2019)
     Bushfire Resilient Communities. Technical Reference Guide for the State Planning Policy State
       Interest ‘Natural Hazards, Risk and Resilience - Bushfire’ (Queensland Fire and Emergency Services
       (QFES), 2019)

QFES, 2019 states that although state-wide bushfire prone area mapping is regularly updated, land use
and vegetation cover (key contributors to bushfire hazard) are subject to change, particularly regarding
the extent of hazardous vegetation. Accordingly, the first step of a bushfire hazard assessment is to
undertake a reliability assessment to determine whether the site’s observed characteristics are consistent
with the inputs used to create the mapping and the mapping outputs. A reliability assessment is therefore
undertaken for the site and all land within 150 metres of the proposed development.

The preparation of a Local Hazard Area Map has been undertaken for the site in accordance with the
methodology described in the above referenced documents. The input parameters used to determine the
bushfire hazard acting on the site are detailed in the sections below.

2.1.2   Vegetation Hazard Classes
Fuel loads need to be determined when preparing a bushfire hazard assessment. The QFES refers to the
process for identifying, classifying and mapping vegetation hazard classes as a Vegetation Hazard Class
Assessment. In accordance with the methodology outlined in Section 6 of the Bushfire Resilient
Communities (QFES, 2019), the following Vegetation Hazard Classes (VHC) were identified within the
assessment area (which includes a 150m buffer surrounding the proposed build location):
     VHC 3.1 – Notophyll vine forest – which is attributed a combined surface/near-surface fuel of 4.5t/ha
        and a total potential fuel load of 4.5t/ha
     VHC 40.4 – Continuous low grass or tree cover – which is attributed a combined surface/near-
        surface fuel of 4.5t/ha and a total potential fuel load of 5t/ha



MAY 2022                               BUSHFIRE HAZARD ASSESSMENT                                  Page: 10
                                       74 PENDER CREEK ROAD, KIN KIN