Council archive · source document
SUPERSEDED - Decision Notice - MCU22 0145 & OPW22 0212 [As Published] · MCU22/0145
Amendments • Remove/setback architectural features including the rendered
concrete façade profiles and flat roof at Level 3 to a minimum
of 10m from the front boundary.
• Revise as per Condition 9.
C3.7 - Section 8 04.07.23
Amendments • Remove/setback architectural features including the rendered
concrete façade profiles and flat roof at Level 3 to a minimum
of 10m from the front boundary.
• Revise as per Condition 9.
C3.8 - Section 9 04.07.23
Amendments • Remove/setback architectural features including the rendered
concrete façade profiles and flat roof at Level 3 to a minimum
of 10m from the front boundary.
• Revise as per Condition 9.
*(Refer to Advisory Note)
Building Height
4. The maximum height of the development must not exceed 12 metres above the natural
ground level and the exposed portion of the external façade of the building including where
excavation is undertaken.
5. The ground level must be reinstated around the basement level to ensure no part of which is
more than 1 metre above ground level, apart from the driveway entrance.
6. Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
certifies that the building does not exceed the maximum height requirement of this Decision
Notice.
Building Appearance
7. External design features, materials and finishes must be as shown on the Approved Plans,
with no inclusions or alterations made without approval in writing by Council, apart from as
conditioned as plan amendments.
8. External finishes of the building must be a mix of lightweight and textured external finishes,
with masonry areas incorporating a variety of textured finishes to break up the surface.
9. With the exception of the lift shaft and stairs, no wall or privacy screen at Level 4 must be
higher than 1.7 metres.
10. All deck and balcony areas must not be enclosed with shutters, louvres, glass panelling or
the like thus remaining as open structures, except where required to satisfy any privacy
condition of this Decision Notice.
11. All balustrades to decks and balcony areas must be open or transparent.
12. External colours and finishes must be of an understated colour scheme and low-reflective
roofing and cladding materials.
13. The development must not exceed a maximum plot ratio of 0.65:1 with the areas identified
as voids on the Ground Floor, Level 2, Level 3, and Level 4 to remain open as full open void
areas at all times.
14. All air conditioning units or other mechanical equipment must be fully enclosed or screened
such that they are not visible from the street frontages nor adjoining properties.
15. Waste storage areas, clothes drying areas and external storage areas must be screened
from view of the street.
Page 4 of 18
Document Set ID: 22549607
Version: 4, Version Date: 22/08/2023
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
SUPERSEDED - Decision Notice - MCU22 0145 & OPW22 0212 [As Published].pdfRelated documentApplication case desk ↗
About this file
- File size
- 218 KB (small file)
- File type
No other editions are linked here.