Council archive · source document
Apdx 1 - Proposal Plans · MCU24/0001
Plans and drawings: the text below has words only, no drawings.
Original PDF page 2, section 1. The text section number identifies this passage in the reader.
GENERAL NOTES & INFORMATION DRAWING LIST PROJECT NOTES
SHEET # SHEET NAME REV. DATE
Site Plan Notes Roof Construction
The builder is responsible to check all
Surface water drainage must be prevented Colorbond sheet metal to be fixed in accordance
existing services prior to beginning any
from entering the building with FGL sloping with manufactures specification. 00 Title Page 18/12
construction.
away from the building & finished slab levels. All ridge capping, steps, hips valleys and vent 01 General Notes 18/12
The builder is responsible to check all flashings to provide waterproofing system.
# Denotes cavity slider to manufactuers 02 Site Plan 18/12
specification, frames containing cavity sliders existing services prior to beginning
construction. Provide reflective foil backed sarking to underside 03 Ground Floor Plan 18/12
to be 90mm minimum U.N.O
of roof sheeting. Colorbond guttering and PVC 04 Ground Floor - Dimensions 18/12
Stabilised cut and fill batters to be a Downpipes to be connected to Stormwater
Builder to verify all dimensions prior to 04a Ground Floor GFA 18/12
minimum of 1000mm away from footings systems in accordance with the local authority.
beginning construction work. 05 First Floor Plan 18/12
and are to have 1 in 1 max. gradient.
Grade finished surface level Roof water requirements and calculations are 06 First Floor - Dimensions 18/12
Electric HWS to minimum energy efficiency
from slab and footings. provided as a guide. Ensure a qualified plumber/
regulations. 06a First Floor GFA 18/12
hydraulics consultant reviews the downpipe
Position of proposed building to layouts prior to construction. 07 Elevations 18/12
Toilets: minimum 4-star dual flush, as rated
be verified by builder on site. 08 Elevations 18/12
under the Water Efficiency and Labeling
Location of existing services to be qldBUILT has provided downpipe locations as a
Standards scheme (WELS). 09 Sections 18/12
verified by builder prior to construction. guide only. Layout to be checked for compliance
by qualified persons prior to ordering and 10 Sections 18/12
Tapware: minimum 3-star WELS rated for
Wall Construction construction. 26 Landscaping & Site Cover 18/12
kitchen sinks, basins and laundry troughs.
Wall framing to be constructed in All slotted gutters and downpipes to be installed R01 Exterior Renders 18/12
accordance with engineering specification to NCC and or AS3500 (relevant parts). Materials
Showerheads: minimum 3-star WELS rated R02 Exterior Renders 18/12
and must not differ from certification used are to be compatible with all components
showerheads.
covered by the Form 15. Cladding upstream and down stream. R03 Exterior Renders 18/12
SD Smoke alarms complying with AS 3786 systems to be fixed in accordance with R04 Exterior Renders 18/12
to be installed and connected to consumer manufactures specification.
Termite Risk Management R05 Exterior Renders 18/12
mains power in accordance with NCC part Method to be in accordance with the T01 WPH&S & Revision Schedule 18/12
3.7.2 Wet Areas
Floors in "Wet Areas" to be impervious in NCC Part 3.1.3 and other relevant
accordance with Australian Standards. manufacturer specification. All new
All electrical appliances and plumbing symbols work shall be protected from termite
are diagrammatical. Refer to builders Finish and fall gradients to floor wastes.
attack in accordance with AS 3600.1
specification for details all fixtures. "Protection of the Building from
Glazing Construction
Powdercoated Aluminum Frame Subterranean Termites AS2870 Part
Seal wet areas in accordance with N.C.C. Vol. 2. 1 New Building Slabs.
Part 3.8.1. Slope floor surface towards fw Windows in accordance with AS 4055
(floor wastes) "wind loads for residential" & AS 1288
Provide lighting in accordance with N.C.C. Vol. 2. "Glass in Buildings selection and Dimensions Note:
Part 3.8.4.2 & 3 installation" All wall dimensions are taken from
Provide ventilation in accordance with N.C.C. the outside faces of the stud wall.
Vol. 2. Part 3.8.5 Soffit Construction (i.e. selected cladding over omitted for
Mechanical ventilation in accordance with N.C.C 4.5mm F.C Sheeting and Painted clarity excluding brick veneer walls).
Vol. 2. and AS1668.2 (Raked)
Waterproofing & Water Resistant Climate Code Requirements
Materials Energy efficiency assessor to confirm
Minimum Design Standards All wet area waterproofing is to adequacy of proposed construction.
Construction of this building to be in comply with AS3740, waterproofing Provide insulation to N.C.C. code requirements
accordance with the following Australian wet areas in residential buildings. or to BERS certification requirements.
governing bodies.
♦ National Construction Code (NCC)
NCC Vol2 P3.8.1.0
All waterproofing material systems
DRAWING SET REVISION HISTORY
♦ Queensland Development Code components to be installed to REVISION SCHEDULE
♦ Standard Building Regulation 2006 manufacturers specification. Number Description Date Issued by
♦ Local government planning policies Instructions and material capability to 1 Developed Drawing Set A 22/11/23 PD
♦ Estate Design Guidelines be checked prior to construction. 2 Amendments to upper floor 28/11/23 PD
3 Amendment to upper floor layout 29/11/23 PD
4 Section & plan updates 01/12/23 PD
5 Amendments to FFL's 18/12 PD
PROJECT ADDRESS : PROJECT C COPYRIGHT
DIRECTOR : DESIGN TEAM : DATE : 18/12/23 A3
Dominic Tyacke Aaron Waters
STATUS: Developed Drawings - C
E : [email protected] E : [email protected] 2 Jan Street CLIENT :
The drawing and the design depicted on this sheet
remains the property of qldBUILT. Reproduction in part
or whole is prohibited unless written permission is
PROJECT NUMBER: SHEET NUMBER:
M : 0410 332 167
Q.B.C.C LICENCE NO. : 15035880 QLDBUILT PTY LTD
W: www.qldbuilt.com.au
Phil Darwen
E : [email protected]
Noosa Heads Venter, Greg & Keri obtained from qldBUILT. Plans are designed for use on
the job address specified in the titleblock only. 23-007 01
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Apdx 1 - Proposal Plans.pdfRelated documentApplication case desk ↗
About this file
- File size
- 4.2 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.