Skip to the record
Accept no substitutions.

Council archive · source document

Extract Planning Scheme 20222 · OPW22/0022

of 23

Text shows just the words. Original shows the document exactly as it was published.

                   (g)      When constructing mounding or banks, highly compacted fill material in the top 600 millimetres should be avoided
                            as this can impede root penetration and the successful growth of plants; and
                   (h)      Maintain maximum fall of 1:3 to ensure stability of mulch on slopes and allow for access for maintenance. Refer to
                            Figure SC6.3.2.


  Figure SC6.3.2




  (17)    Planting Procedures
          (a)    Correct planting procedures ensure greater success in establishment of landscapes. The following points should be
                 complied with:
                 (i)      Do not plant in extreme hot, cold or atmospheric disturbances;
                 (ii)     Dig separate holes for each plant, 100 millimetres wider and deeper than container. Loosen soil at base of holes a
                          further 150 millimetres in depth. Fill holes with water and allow water to drain away. Refer to Figure SC6.4.3 and
                          Figure SC6.4.4;
                 (iii)    Position plant in centre of hole, set and backfill, retaining original soil level of container. Only tease out roots if root
                          ball is compacted or pot­bound;
                 (iv)     Incorporate suitable fertiliser and/or water crystals, if required, at time of backfilling ­ refer to section (20);
                 (v)      Gently and firmly tap down around root ball, leaving a shallow watering depression. Water immediately and
                          thoroughly using a minimum of 5 litres per plant;
                 (vi)     Mulch after planting (and installation of irrigation if applicable) ­ refer to section (18) Mulch types;
                 (vii)    Where mulch is already in place, it should be raked well back from around the area and the hole dug. Excess soil
                          should be removed or spread prior to replacing mulch to prevent mixing of the two mediums; and
                 (viii)   Plants that are severely root bound are not to be used.

  Figures SC6.3.3 Planting in Level Areas




  Figure SC6.3.4 Planting on slopes




Document Set ID: 21791825
Version: 1, Version Date: 18/01/2022                      NOOSA PLAN 2020                                                                       Page 23 of 99

Used in these records

About this file

File size
522 KB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Extract Planning Scheme 20222.pdf · 522 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.