20210041 Bottlebrush Ave RECOR RFI Response

            25th February 2022

            Ref:    MCU21/0214 & OPW21/0356

            Noosa Council
            PO Box 141
            TEWANTIN QLD 4565


            Attention:                        Lisa Pienaar

            Dear Sir,

                        Re:                   Information Request
                        At:                   27 Bottlebrush Ave, Noosa Heads, QLD 4567


            With reference to the abovementioned information request for the development
            application (ref: MCU21/0214 & OPW21/0356), we have prepared an update to the
            engineering aspects of the submission to address the issues raised in the Request for
            Information as follows:

            15. Provide a more detailed longitudinal section of the access driveway. The plan
            must be prepared by an RPEQ and extend from the centreline of the road formation to
            the garage floor level. The plan must include but not be limited to:
                   a. Levels and grades;
                   b. The vehicle clearance for a B99 vehicle as described in AS/NZS2890.1:2004;
                   c. Sufficient detail to demonstrate that vehicles will not bottom out or scrape
                   on the road formation or driveway when entering and exiting the site.

            The grades of the longitudinal section have been updated and vertical clearance
            envelopes for a B99 vehicle as described in AS/NZS2890.1:2004 have been generated
            using AutoTurn software for both access and egress movements of the driveway to
            demonstrate that vehicles will not bottom out or scrape on the proposed alignment. The
            vertical alignment profile is now provided on plan C40 – Swept Path Analysis.


            16. Provide amended plans that indicate the existing services in the frontage adjacent
            to the driveway and the vegetation in the road reserve in front of the adjacent property
            that may be impacted by the proposed works.

            17. Provide detail on how the impacted existing services and vegetation will be
            protected during the construction of the driveway.

            The plans have been amended based on the revised vertical alignment and adjusted
            batter slopes in proximity to the services to achieve a minimum clearance of 200mm from
            the services identified in the survey. This area if proposed to be protected by erecting an
            orange and yellow bunting mesh barrier fence to ensure a works exclusion zone is evident
            to protect these services. The earthworks are also approximately 1.5m clear of existing
            vegetation within the road reserve so works are not expected to impact the existing trees.




P +61 7 5211 1003         A 37 Mary St, Noosaville Qld 4566     E [email protected]   recorconsulting.com