Minor Change Existing Approval - 132001 210307 1 (As Published) · 132001.210307.1

               4.     ASSESSMENT MANAGER CONDITIONS

               Environmental Health
               1.     An annual licence is required under the Health Regulations 1996 from Council’s
                      Environmental Health Section where hairdressing or skin penetration is to be performed on
                      the premises.
               2.     The developer must provide a suitably screened imperviously paved area large enough for
                      all refuse and recycling containers. A wash down area is required with a cold-water tap,
                      hose and drain outlet connected to sewer. The drain outlet is to be designed to prevent
                      stormwater entry to the sewerage system.
               3.     Refuse containers must be provided in accordance with the requirements of the
                      Environmental Protection (Interim Waste) Regulations 1996 and (Waste Management)
                      Regulation 2000, for the storage and collection of refuse.
               4.     The development must be undertaken and operated in a manner that causes no detrimental
                      effect upon the amenity of the neighbourhood by reason of the creation of excessive noise,
                      lighting, dust or odour nuisance or any other emissions in accordance with the nuisance
                      provisions of the Environmental Protection Regulation 1998. On the spot fines apply for such
                      offences.
               5.     Air conditioning units shall be located in a manner which prevents noise nuisance beyond
                      the subject land in accordance with the nuisance provisions of the Environmental Protection
                      Regulation 1998. On the spot fines apply for such offences.
               6.     Commercial premises that generate trade waste and will discharge that waste to sewer, must
                      have that waste suitably treated before release to sewer.
               Building
               7.     The plans submitted for a Development Permit for building works are to comply with the
                      approved plans and the following requirements:-
                      7.1     Openings located within 3 metres from side or rear boundary are required by the
                              Building Code of Australia Clause 6.3.2 to be protected by one of the acceptable
                              methods outlined in Clause C3.4 of the Building Code of Australia.
               Land Development
                      Vehicle Access
               8.     Vehicle access to and from the site shall generally be in accordance with proposal plan 3001-
                      aa, dated 12/12/01 as submitted by Graham Matheson Licensed Building Designer, except
                      as modified herein.
               9.     The proposed one-way vehicle access driveway from Council’s carpark (located to the north
                      of the site) shall be no wider than 3.0 metres in width.
               10.    A landscaped buffering-median shall be provided both sides of the one-way vehicle access
                      driveway within Council’s carpark at no cost to the Council.
               11.    The driveway within the site, that also provides access to the proposed carpark, shall be at
                      least 5.4 metres in width and the proposed one-way exit driveway onto Doonella Street shall
                      have a maximum width of 3.0 metres.
               12.    The applicant shall ensure appropriate measures are in place to prevent access to the site
                      from Doonella Street.
               13.    All vehicles shall enter and leave the site in a forward direction.
               14.    On-site landscaping shall not interfere with the sight distance of on-road traffic or vehicles
                      exiting the site.




                                                                                                       Page 2 of 9
Document Set ID: 23994688
Version: 5, Version Date: 06/08/2025