Development Application part 7 of 10 Stormwater Management Report - MCU13/0092

     4.   Emergency Procedures

4.1 Spill Procedures



 In the event of a spill discharging into
                                          any gully pit all sediment is to be extracted and the filter bags are to be
 removed and replaced with rejuvenated filter bags. Normal
                                                                 operation procedures apply to additional cleaning
as a result of   spills.



4.2 Blockages

In the unlikely event of surface flooding around a gully
                                                              pit fitted with an Enviropod the following steps should
be carried out:


Check Enviropod over flow bypass. The Enviropod filter has been
                                                                       designed with an overflow mechanism built
into the filter box. If surface flooding still exists check the overflow slots underneath the rubber seal. If
                                                                                                                  debris
is lodged in the overflow slots these can be easily cleared
                                                                by hand or steel rod.

If overflow is clear and surface flooding still exists remove
                                                                Enviropod and check outlet pipe for blockages.

Removal of the Enviropod may be difficult if the filter is clogged and the
                                                                            Enviropod is holding water. If the
filter is clogged, brush the side walls of the filter with a yard broom or similar. This will
                                                                                                      dislodge particles
trapped at the interface allowing contained water to flow through the filter.

If the outlet pipe is blocked, it is likely that a gully sucker truck will be
                                                                                required to unblock it. Debris should be
removed from the Enviropod with the gully sucker truck before removal of the
                                                                                        Enviropod filter.

If a gully sucker truck is not available and the Enviropod needs to be removed
                                                                                       by hand, follow the steps below:
    Remove excess debris by hand or brush the side of the filter.
    Lift and place filter ring through the filter box and into cage.
    Remove Filter box.
    Lift cage containing filter bag and ring out ofthe pit.
    Unblock outlet pipe.




(92011 Stormwater360