MCU14/0056 Response to SARA - Consulting Report

EN 858-1:2002 (E)

This standard does not apply to the treatment of stable emulsions, solutions of light liquids and water, grease and
oils of vegetable and animal origin.

2 Normative references

This European Standard incorporates by dated or undated reference, provisions from other publications. These
normative references are cited at the appropriate places in the text and the publications are listed hereafter. For
dated references, subsequent amendments to or revisions of any of these publications apply to this European
Standard only when incorporated in it by amendment or revision. For undated references the latest edition of the
publication referred to applies (including amendmenis).

ISO 48, Rubber, vulcanized or thermoplastic— Determination of hardness (hardness between 10 IRHD and
100 IRHD). ‘

ISO 178, Plastics — Determination of flexural properties.
ISO 180, Plastics — Determination of Izod impact strength.
ISO 185, Grey cast iron — Classification.

iSO 527-2, Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion
plastics.

ISO 630, Structural steels — Plates, wide flats, bars, sections and profiles.

ISO 877; Plastics — Methods of exposure to direct weathering, to weathering using glass-filtered daylight, and to
intensified weathering by daylight using Fresnel mirrors.

{SO 1083, Spheroidal graphite cast iron — Classification.

ISO 1133, Plastics — Determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of
thermoplastics.

ISO 1183, Plastics — Methods for determining the density and relative density of non-cellular plastics.

ISO 1518, Paints and varnishes — Scratch test.

ISO 1817, Rubber, vulcanized — Determination of the effect of liquids.

ISO 1920, Concrete tests - Dimensions, tolerances and applicability of test specimens.

ISO 2409, Paints and varnishes — Cross-cut test.

ISO 2736-1, Concrete tests ~ Test specimens — Part 1: Sampling of fresh concrete.

ISO 2736-2, Concrete tests — Test specimens — Part 2: Making and curing of test specimens for strength tests.
ISO 2808, Paints and varnishes — Determination of film thickness.

, ISO 2812-1, Paints and varnishes — Determination of resistance to liquids — Part 1: General methods.

ISO 2812-2, Paints and varnishes, determination of resistance to liquids, Part 2 : water immersion method.
ISO 2815, Paints and varnishes — Buchholz indentation test.

{SO 3755, Cast carbon steels for general engineering purposes.

ISO 4012, Concrete — Determination of compressive strength of test specimens. co

ISO 4624, Paints and varnishes — Pull-off test for adhesion.

This is a licensed reproduction produced by SAI Global Ltd, an authorized distributor of British Standards