MCU14/0056 Response to SARA - Consulting Report

EN 858-1:2002 (E)

Annex ZA
(informative)

Clauses of this European Standard addressing the provisions of EU
Construction Products Directive

ZA.1 Scope and relevant characteristics

This European Standard has been prepared under the Mandate Mi 1811 given to CEN by the European
Commission and the European Free Trade Association.

The Clauses of this European Standard shown in this Annex meet the requirements of the mandate given under
the EU Construction Products Directive (89/106/EEC).

Compliance with these Clauses confers a presumption of fitness of the separator systems for light liquids covered
by this Annex for their intended use; reference shall be made to the information accompanying the CE marking.

WARNING — Other requirements and other EU Directives, not affecting the fitness for intended uses, can
be applicable to the separator systems for light liquids falling within the scope of this European Standard.

NOTE 1  !n addition to any specific Clauses relating to dangerous substances contained in the standard, there may be other
requirements applicable to the products falling within its scope (e.g. transposed European legislation and national laws,
regulations and administrative provisions). In order to meet the provisions of the EU Construction Products Directive, these
requirements need also to be complied with, when and where they apply.

NOTE 2 An informative database of European and national provisions on dangerous substances is available at the
Construction web site on EUROPA (accessed through
http://europa.eu.int/comm/enterprise/construction/internal/dangsub/dangmain.htm).

This Annex establishes the conditions. for CE marking of separator systems for light liquids intended for the use
indicated in the.relevant Clauses applicabie (see Table ZA.1).

Table ZA.1 — Scope and relevant Clauses

 

 

 

 

 

 

 

 

Product: Separator system for light liquids (e.g. ofl and petrol) as covered by scope of this standard
Intended use: Separate light liquids from wastewater to protect sewerage systems and surface water
Essential Requirement Levels and/or classes Notes

Characteristics Clauses in this Standard

Reaction to fire 6.2.8 Al toF —_

Liquid tightness 6.3.2 None Pass/fail

Effectiveness 4, 6.3.1, 6.3.3 to 6.3.8, 6.5 None . Pass/fail

Load bearing 6.4 None Pass/fail

capacity

Durability 6.2 None Pass/fail

 

 

 

 

1 Mandate M/118 “Wastewater engineering products” as amended.
This is a licensed reproduction produced by SAI Global Ltd, an authorized distributor of British Standards 51