Judgment - PECA 24.25 - 19.06.2026

      An applicant for a development application may make an agreement with an assessment
      manager, referral agency or other person to establish the responsibilities, or secure the
      performance, of a party to the agreement about a development condition.
      Building Form and Development Appearance
9.    The two Pergolas shown on the approved plans at the roof level are not to be roofed or
      covered in an impermeable membrane and are not to exceed 2.2 metres in height.
10.   The maximum height of the development must not exceed the building heights shown on
      the approved plans, as amended by conditions of this approval, above ground level.
11.   Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld)
      which certifies that the buildings do not exceed the maximum height requirement of this
      Decision Notice.
12.   External design features, including the extent of fixed or operable screens fronting all
      streets, materials, colours and finishes must be shown on the Approved Plans and
      submitted to Council for written approval from the Development Assessment Manager prior
      to the issue of Building approval. No inclusions or alterations are made without approval in
      writing by Council.
13.   Additional detailed plans and interior elevations showing appearance and design
      treatments of internal view corridors highlighted by Council in the Internal Views bundle
      (NSC mark-up) to be submitted to Council prior to the issue of any Operational Works
      Permit. The design of these areas must not result in an increase in the gross floor area of
      the development.
14.   All deck and balcony areas must not be enclosed with shutters, louvres, glass panelling or
      the like thus remaining as open structures.
15.   All balustrades to decks and balcony areas must be open or transparent.
16.   All air conditioning units or other mechanical equipment must be fully enclosed or screened
      such that they are not visible from the street frontages nor adjoining properties.
17.   Any security screens on the premises consist of grille or translucent screens and not solid
      shutters, screens or roller-doors.
18.   All mechanical equipment and other service infrastructure, with the exception of a fire
      booster, Energex pad mount transformer and bio-retention basin, located on the site must
      be:
      a.   located not less than 2 metres from a property boundary;
      b.   fully enclosed or screened such that they are not visible from the street frontages nor
           adjoining properties. Where screened by landscaping, landscaping beds must be at
           least 1.5 metres wide.
19.   No part of the site may be used for outdoor storage of materials.
      Amenity
20.   The operation of the approved use must not unreasonably detrimentally affect the
      residential amenity (including but not limited to noise, amplified music, overlooking, light
      spill or odour) enjoyed by surrounding residents or cause a nuisance, including a noise
      nuisance.
21.   Deleted
22.   Deleted
23.   Service vehicle movements associated with non-residential uses on the premises
      (including loading and unloading) must not occur outside the hours of 6am to 6pm, 7 days
      per week. The requirements of this condition must be included in the Community
      Management Statement for any body corporate for the subject site.




                                                                                    Page 4 of 12     4