SUPERSEDED Compiled Approved Plans for OPW20-0145 05

                 Structural Root Zone (SRZ) (AS 4970-2009)
                 The area around the base of a tree required for the tree’s stability in the ground. The woody root growth and soil cohesion
                 in this area are necessary to hold the tree upright, so the entire profile (depth) of the root zone is included in the Structural
                 Root Zone (SRZ). The SRZ is nominally circular with the trunk at its centre and is expressed by its radius in metres.

                 This zone considers a tree’s structural stability only, not the root zone required for a tree’s vigour and long-term viability,
                 which will usually be a much larger area.

                 The SRZ is the critical area required for tree stability and does not consider tree health, which will generally require a much
                 larger area. While there are many factors that affect the actual size of the SRZ (e.g. tree heights, crown area, soil type, soil
                 moisture, etc.), the area determined using the trunk diameter provides a general guide indicating where structural roots are
                 likely to be located. Only thorough root investigation would show the actual location of these roots. Determine SRZ radius
                 from the trunk diameter (measured immediately above the root buttress) using the following formula or Figure 1.

                           SRZ radius = (D x 50)0.42 x 0.64
                 where
                           D = trunk diameter, in metres, measured above the root buttress

                 Note: The SRZ for trees with trunk diameters less than 0.15 metres will be 1.5 metres.



                 Figure 1: Structural Root Zone




                 The curve can be expressed by the following formula:
                          RSRZ = (D x 50)0.42 x 0.64


                 NOTES:
                     1.    RSRZ is the Structural Root Zone radius.
                     2.    D is the stem diameter measured immediately above root buttress.
                     3.    The SRZ for trees less than 0.15 metres diameter shall be 1.5 metres
                     4.    The SRZ formula and graph do not apply to palms, other monocots, cycads and tree ferns.
                     5.    This does not apply to trees with an asymmetrical root plate.


                 Source: Australian Standard Protection of Trees on Development Sites AS 4970-2009




                 Arborist Report for 28 Eenie Creek Road, Noosaville
                 Prepared by Arbor Operations – July 2020
Document Set ID: 21753628
                  21426255
                                                                                                                                   18 | P a g e
Version: 1, Version Date: 12/01/2022
                          24/03/2021