Skip to the record
Beware of cheap imitations.

Original source · versioned page text

SUPERSEDED Compiled Approved Plans for OPW20-0145 05

of 228

Page text read automatically using OCR, there may be inaccuracies

Plans and drawings: the text below has words only, no drawings.

Very large file (73.7 MB): may take a few minutes to open.

Log in to see the plans as drawn

Original PDF page 140, section 1. The text section number identifies this passage in the reader.

                     4.7. Clearing Methodology

                               a) After under scrubbing of each area is complete, non-habitat trees (i.e. trees other
                                   than those identified as habitat trees) will be cleared and stockpiled for mulching.
                                   Clearing of non-habitat trees will only occur where their removal will not impact on
                                   identified habitat trees (e.g. canopies do not interconnect with habitat trees).
                               b) After under scrubbing and clearing on non-habitat trees, an elevated work platform
                                   or EWP will be used in conjunction with a chainsaw operator and suitably qualified
                                   fauna spotter/catcher to inspect and remove hollows a necessary prior to habitat tree
                                   felling. This method involves the fauna spotter/catcher inspecting each of the
                                   potential habitat features (usually hollows, dreys and arboreal termite nests) to
                                   determine the presence of arboreal fauna. This process is detailed following the step
                                   by step basis below:
                                   1. The fauna spotter/catcher (with arborist unless the fauna spotter/catcher is a
                                         qualified chainsaw operator) will inspect each visible hollow or potential habitat
                                         resource (i.e. ringtail possum drey) identified in each tree using the EWP. This is
                                         usually carried out by simply looking into hollows with the assistance of a small
                                         torch, however, burrow and bore-scopes can also be useful for deep hollows.
                                   2. If fauna is located within a hollow, a piece of towel or rag will be firmly laced in
                                         the entrance to prevent the wildlife form escaping as in most cases arboreal fauna
                                         become aware of the presence of the fauna spotter/catcher and may attempt to
                                         flee the nesting/denning hollow due to a perceived threat. If an occupied ringtail
                                         possum drey is encountered, the fauna spotter/catcher should quietly approach
                                         (i.e. avoid contacting other branches) the drey in the EWP bucket and physically
                                         capture the possum by placing the entire drey in a catch bag or only the possum
                                         if it emerges from the drey.
                                   3. Once the hollow entrance has been secured the arborist or fauna spotter/catcher
                                         will cut the entire hollow limb off below the cavity where the branch remains
                                         solid. In circumstances where a hollow continues into the main stem of the tree,
                                         a small window will be carefully cut into the hollow, allowing the fauna
                                         spotter/catcher to plug the hollow above and below the window, then the hollow
                                         limb removed and lowered to the ground in sections.
                                   4. When the fauna has been safely secured within its hollow, the entire limb can
                                         then be placed in the EWP bucket or lowered to the ground using ropes depending
                                         on the size of the limb.
                                   5. This limb will then be placed in a cool, quiet location until translocation to the
                                         recipient habitat site, when at dusk the follow entrance is re-opened to allow the
                                         fauna to emerge of its own accord.
                          (f) Provide a written report to council following clearing that addresses the following:
                              Fauna Report detailing:
                                   (i) The length of clearing time.
                                   (ii) Animal trapping prior to and during clearing.
                                   (iii) Animal relocations.
                                   (iv) Fauna injuries and euthanisations.
                                   (v) Monitoring findings from nest boxes


                                                                                                                23 | P a g e

Document Set ID: 21753628
                  21426255
Version: 1, Version Date: 12/01/2022
                          24/03/2021
Log in to download the original file

SUPERSEDED Compiled Approved Plans for OPW20-0145 05.pdf · 73.7 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.