Proposal Plans · OPW22/0140

Notes:
= Thoroughly water the root ball
immediately after planting

   
  
  
    
 
        
  

Form earthen watering
dish around base of plant.

Pull mulch away from
base of plant.

Do not allow fertiliser to
‘come in contact with roots.

Imported soll blend

Water retention additive

¢ ) PLANTING DETAIL: TUBESTOCK

Notes
- Use edge profile as indicated below,

~ Edge radii shall be 20mm,

= Install concrete edge on minimum 150 deep
compacted base.

- Finished surface levels shall be as shown on
edge profiles.

= Place tool joints at minimum 5m centres,

- Make tool joints at equal distances from both
ends. Make joint at points of change in
curvature/ direction, Joints to be at right angles
to direction of edge.

110
FEL. FSL.

¢ s ‘ EDGE TYPE 14 - EXTRUDED CONCRETE

Notes:
Place the rootball on a firmed base to
achieve required FSL.

= Thoroughly water the root ball
immediately after planting,

= Number of stakes will vary with pot size.
Refer plant schedule.

- Cultivate sides and base of excavated
hole 50mm. Apply Gypsum @ 100g/m2.

Pull mulch away from
base of plant

Form earthen watering dish
around base of plant.

CEES.
Water retention additive
Imported soil blend
Do not allow fertiliser to eS

 
 
   
  
 
  
 
  
 
 
  

come in contact with _
roots.
Cuttivated area

¢ - ‘ PLANTING DETAIL: 140-300mm.

FSL

3

 

Timber edge

Y Stakes

i batrocmge

/subgrade/subase

   

 

 

 

( f 5 EDGE TYPE 2 - TIMBER EDGE

Notes
~ Al timber to be treated to AS1604, Hazard 4,
rough sawn pine unless otherwise shown.

~ Allfixings to be hot dipped galv

~ Leading edge isto be free of burrs and
splinters,

Timber Edge: 120x36mm pine

Stakes’ 45%45mm HWD to be 400mm into
ground at max. Space at 1200mm centres, or
8 required to oblain smooth curves. Top of
stake to finish 20mm below top of timber
ledge. Where timber edges meet at corners
provide double stakes,

Fixings: 2x60mm galvanised nails

 

Notes:

= Place the rootbal on a fimed
base to achieve required FSL

- Thoroughly water the root ball
immediately after planting,

= Number of stakes will vary with
pot size. Refer plant schedule.

~ Cuttvate sides and base of
excavated hole 50mm. Apply
Gypsum @100g/m2.

Hardwood stake: Place 600mm of —>
into the ground, Do not piace
through rootball. Secure with ties
by looping in a figure eight pattem.

Raise plant Somm above
finished surface level

Pull muich away from base

of plant.

Form earthen watering dish
around base of plant,

Imported soil blend:
Water retention additive

Do not allow fertiliser to
come in contact with roots.

Cultivated area —__»

varies

300

  
   

 

 

 

 
 
   
  

 

 

J : Lowa ho I

 

¢ 3 + PLANTING DETAIL: 45-200Ltr

Notes:

- All subsurface pipes to fall evenly to storm water system.

- Join drains to upvc conduits on same diameter when
placing under paved areas or areas that require compacted
sub-base,

- Sub-soil pipe to be 100mm dia. with fiter sock

 

 
 
 

Imported soil blend under turt

  
 
  

10mm - 20mm drainage
aggregate

SS

CR

yy
oO
Ay
SS
OUR,
°
5

KK
y
CA
g
a
¥
&
%

¢ Z - SUB SOIL DRAINAGE

Notes:
= Mulch: 100mm deep of 25mm Hoop Pine Mulch

- Soil: Provide sufficient soi to fill planters to 100mm below
top of wall. Lightly compact soil in 200mm layers. Use
Premium grade soil blend with high sand content to reduce
slumping, Mix with HyGrocell Flake at 30% by volume.

= Waiter retention: Provide 100mm thick Hydrocell hard foam
to base of pianter.

= Refer to Structural Engineers dwgs for waterproofing,
drainage and connections.

Rockcote render
totop
Mulch
Rockcote |
render to face
Imported soil blend:
Wiaterproot
membrane
Water retention layer
Geotextie fabric
Drainage layer
Reinforcing ler
cineers cravings
Podium slab} <— ed, ?

Planter drain. Connect —}—s
to SW system, P

  
  

pe

 

 

 

 

 

External Works digs.

Height varies. Refer to

 

 

 

 

 

 

 

 

 

 

 

 

 

( A + PODIUM PLANTING DETAIL

Notes:
= Ensure enough room bel
construction,

 

 

{0 allow for safe access during

- Concrete block wall reinforced and core file.
- Blocks 390mm x 190mm typical with 10 mm joints.

= Waterproof membrane to wrap over structural slab. Refer to
Structural Engineers specification.

- Refer plans for adjacent surface treatment.

Podium planting area. Refer
to detail
Reinforced block wall

Rockcoat

Waterproof membrane

Steel reinforcing

   

<< Structural slate

gS WALL TYPE 1