Attachment 1 - Stormwater Management Plan

                                                                Ocean Protect | OceanGuard Installation Guide
Rev: 1 Last Updated: March 2019


Introduction
The purpose of this manual is to indicate the safest and most efficient method in installing the Ocean
Protect OceanGuard.

Equipment
The following personal protective equipment is required by staff for installation activities:
        Puncture resistant gloves
        Steel capped safety boots,
        Long sleeve clothing, overalls or similar skin protection
        Eye protection
        Hearing protection
        High visibility clothing or vest
Note: The above list is a guide only, all individuals performing installation should evaluate their own OH&S
requirements as required by law or site specific safety requirements.
Typical tools required for installation include the following
        Tape measure                                              Hammer
        Marking Template                                          Stanley knife
        Marking spray paint                                       Straight edge
        8mm masonry drill                                         10mm socket and ratchet
        5 mm steel drill                                          Hacksaw
        Pop Riveter for 4.8mm rivets

Components




                                      Figure 1: OceanGuard components

                                                                                                  Page 1 of 5