Council archive · source document
landscaping · OPW24/0043
Notes:
- Place the rootball on a firm base.
- Thoroughly water the root ball immediately after planting.
- Cultivate sides of excavated hole 50mm deep. Notes:
- Do not disturb kerb, road pavement or road side drainage works. - Place the rootball on a firm base.
Notes: - Tease out roots on side of rootball when planting. - Thoroughly water the root ball immediately after planting.
- Place the rootball on a firmed base to achieve required FSL. - Ensure top of rootball is not buried; expose and set flush with finished level. - Cultivate sides of excavated hole 50mm deep.
- Thoroughly water the root ball immediately after planting. - Do not disturb kerb, road pavement or road side drainage works.
- Number of stakes will vary with pot size. Refer plant schedule. Set soil level at top of - Tease out roots on side of rootball when planting.
- Cultivate sides of excavated hole 50mm. rootball (at flare of trunk) - Ensure top of rootball is not buried; expose and set flush with finished level.
Pull away mulch
from base of plant
50x50x2400 HW Timber stake: Form mulch berm
Place 600mm into the ground. Do to the perimeter of
not place through rootball. Secure the rootball
Hardwood Stake:
25x25x90mm Place 600mm with hessian ties by looping in a
figure eight pattern. Hardwood stake: Place 600mm
into the ground. Do not
into the ground. Do not place
place through rootball.
through rootball. Secure with
Secure with ties by looping Distance to local
Raise plant 20-30mm above ties by looping in a figure eight
in a figure eight pattern. authority
top of kerb. pattern.
requirments
Mulch: Pull away from Raise plant 50mm above
base of plant. Do not excavate finished surface level.
within 50mm of
Mulch: Pull away from base
Form an earthen basin edge restraint or
of plant.
around base of plant. pavement. 100
Top of Kerb Form an earthen basin
FSL around base of plant.
Topsoil blend
50
300
Fertiliser: Do not allow 2
contact with roots. Topsoil blend
min 300
Topsoil blend 1 1
1 Water retention additive
Water retention additive
Bio-degradable Geo-fabric Fertiliser: Do not allow 1
Water retention fertiliser to come in 1
additive contact with roots.
01 140-300mm PLANTING 100mm drainage gravel in width (w)
CD-200 1:10@A1, 1:20@A3 10 - 20mm Drainage gravel
heavy or poor draining soils. Connect drainage gravel 2xw
to back of kerb, subsoil
Incorporate slow release organic drainage where
fertilizer and water retention applicable
additives to backfill per
Manufacturer's recommendations
03 45-200ltr PLANTING
CD-200 1:10@A1, 1:20@A3
FSL
Mulch
- to 100mm depth
Soil blend or site topsoil
- to 300mm depth
02 STREET TREE PLANTING
CD-200 1:10@A1, 1:20@A3
All trees to have 100% NATSPEC inspection prior to delivery to site
Cultivated subgrade
- to 150mm depth
Notes: FSL
(X)
- All timber to be CCA pressure treated to Macrophyte planting with Jute mesh/coir netting. With
AS1604, Hazard 5, rough sawn pine. root ball fully into media and 300mm long pins at twice
Timber edge pull foliage through netting
- All timber edges to be arissed to comply recommended rate to prevent
with council standards. the mesh from lifting.
04 GARDEN BED PROFILE - All timber ends to have one coat of Stakes
CD-200 1:10@A1, 1:20@A3 Cuprinol or equal prior to installation. Filter media and drainage per
- Stakes to be 400mm into ground at max. engineer. Filter media to contain
1200mm centres, or as required to obtain Existing/compacted 75mm thick coarse
5% organics per water by
smooth curves. Top of stake to finish /subgrade/subase straw/ sugar cane mulch
design guidelines
20mm below top of timber edge. Where with minimal fines.
timber edges meet at corners provide
double stakes.
- All fixings to be hot dipped galv.
Turf as specified
- Leading edge is to be free of burrs and
splinters. 07 BIO-BASIN PROFILE
Topsoil CD-200 1:10@A1, 1:20@A3
- to 100mm depth
Cultivate subgrade TIMBER EDGE STAKES (X) = Height above
- to 150mm depth 38 50 finished surface level FIXINGS
Existing subgrade 50mm Bugle Headed
FLUSH
Batten Screws.
100
20mm 75mm Bugle Headed
Batten Screws.
100mm
05 TURF PROFILE 150mm
100mm Bugle Headed
Batten screws.
CD-200 1:5@A1, 1:10@A3 100x38mm
50x50mm
06 EDGE TYPE 1
CD-200 1:5@A1, 1:10@A3
Timber garden edge Revision Date Amendment Drawn Checked
APPROVAL ONLY
CONSTRUCTION DETAILS NOT FOR CONSTRUCTION
A
B
21.03.2022
30.05.2023
For Approval
For Approval
XL & PS
XL
PS
CS
CD-200 scale as noted
ASCOT PLACE - 48 Elm Street, Cooroy QLD
JOB NUMBER: 23123 CLIENT NAME: IRONBARK SMSF PTY. LTD.
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
landscaping.pdfRelated documentApplication case desk ↗
About this file
- File size
- 1.9 MB (small file)
- File type
No other editions are linked here.