Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110

         HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE


WINDOW INSTALLATION                                                    Fit the window within the opening. Ensure the top lip of the
                                                                       window is fitted between the Wall Channel and Wall Sheets.
Stratco Shed Windows are an optional add-on, available in
                                                                       A minimum of four evenly spaced rivets must be used along
both Louvre and Sliding variations. Installation methods are
                                                                       each side of the window frame. All fasteners must be fixed
identical for each window type. Windows can be installed to
                                                                       through the crests of the Wall Sheets (Figure 8.3).
the front or rear wall of the shed.
The Window must be installed during the assembly of the
Rear Wall.

                                                                                                                          Coloured Rivet




                                                                                                                            Wall Channel




                                                                                                          Wall Channel




  Stratco Sliding Window            Stratco Louvre Window
                                                                                                              Window
 FIGURE 8.0


Lay a Wall Sheet on trestles or blocks. Mark and cut 750mm
                                                                       FIGURE 8.3
from the end of the Wall Sheet (Figure 8.1).

                                                                       The Window Flashing must be fitted from the inside of the
                                                                       shed. Fit the short face of the Flashing between the window
                                                                       and the cut edge of the Wall Sheet. Secure the flashing to
                                                                       the Wall Sheet with four evenly spaced Rivets. Ensure all
                                                                       rivets are crest-fixed through to the sheets (Figure 8.4).
                                                                  mm
                                                            750




                                                                                                      Rivet
        Trestles / Blocks

FIGURE 8.1                                                                                                             Window Flashing


Assemble the Wall Assembly as per the “Front/ Rear Wall Assembly”
section of the install guide using below sheet layout (Figure 8.2).




FIGURE 8.2                                                             FIGURE 8.4