Original source · versioned page text
Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110
HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE
Using Trestles or Blocks to support the Sheets, lay down the Corner Wall Sheet and Wall Sheet (Figure 4.1).
Sheet ‘Overlap’
Sheet ‘Underlap’
Wall Sheet
Corner Wall Sheet
FIGURE 4.1
1. Fit the Wall Channel over the lapped Wall Sheets. The end of the Wall Channel should fit up against the end of the Corner
Wall Sheet (Figure 3.2).
2. Fasten through the third pilot hole of both Wall Channel ends and into the Wall Sheet crests. Fasten through the Wall
Channels and into every third Wall Sheet crest using four 10x16 Hex-Head Screws in each Wall Channel (Figure 3.2).
10x16 Hex-Head Screw
Wall Channel
Corner Wall Sheet
Wall Sheet
Wall Channel
1. 2. 2.
FIGURE 3.2
SECOND SIDE WALL ASSEMBLY
Repeat steps in Figures 3.0 - 3.2 to make a second Side Wall Assembly.
Preview the original
The page text is free to read. Previews and downloads of original files need an account.
Log in to previewSearchable page text hides email addresses. Original files are unchanged and may show email addresses.