Skip to the record
Trusted by locals. Built for Noosa.

Council archive · source document

Delegated Report - Code - Planning MCU24 0153 & OPW24 0202 (As Published) · MCU24/0153

of 28

Text shows just the words. Original shows the document exactly as it was published.

                 c. avoid box profiles/parapets; and
                 d. do not create opportunities for overlooking the private open space or internal spaces of
                    neighbourhood properties.


               Assessment
               The proposed development contains two unroofed rooftop terraces accessed exclusively from
               Units 5 and 6. The design includes an open terrace area towards the building’s eastern extent
               (approximately 4.5 metres by 6 metres in dimension) and a plunge pool towards the buildings’
               western side. The eastern area of the roof top terrace will be setback approximately 3.3 metres
               from the northern side boundary.
               To improve privacy to adjoining sites, the terrace floor area and pool will be required to be setback
               a minimum 2.5 metres from the edge of the roof (currently 1.5 metres). This will enable the rooftop
               planters to be widened and also an increased side setback from 3.3 to 4.5 metres (See Fig 8).
               Additional screening landscaping along the northern side will also be conditioned to ensure
               overlooking between properties will be minimised.
               The roof terraces are framed with vegetation across the entire roof level. The roof will not present
               as a boxy profile and will integrate with the presentation of the roof when seen from neighbouring
               sites, ground level and street frontage.




                                                        Figure 8 – Northen roof top terrace



               Side setbacks - PO9 and AO9 of the High Density residential zone code

               Acceptable Outcome AO9.1 of the High Density Residential Zone Code states:
               AO9.1 Buildings and structures meet the following minimum boundary setbacks:
                      a)       for frontages:
                                       i.     First and second storeys - 6 metres
                                       ii.    third storey and thereafter - 10 metres
                          b)           for side boundaries -
                                       i.          1.5 metres setback up to 4.5 metres height;
                                       ii.         2 metres setback between 4.5 metres and 7.5 metres height; and
                                       iii.        2.5 metres plus 500 mm for every 3 metres above 7.5 metres height
                   c) Rear boundary




Document Set ID: 23409043
Version: 7, Version Date: 18/08/2025

Used in these records

About this file

File size
5.5 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Delegated Report - Code - Planning MCU24 0153 & OPW24 0202 (As Published).pdf · 5.5 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.