Skip to the record
For the highest quality transcripts.

Council archive · source document

Attachment 7- Amended Ecological Assessment Report MCU12/208 · MCU12/0208

of 250

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (32.0 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.

Original PDF page 99, section 1. The text section number identifies this passage in the reader.

Noosa on Weyba


(note: during the HBT surveys incidental observations of native flora and fauna were also made).

The raw density of HBTs within each VAT, expressed on a per hectare basis, was estimated using the
following formula:

                                                  D = [n/(TW x TL)] x 10,000

Where:            n = the number of HBTs recorded within the VAT

                  TW = the width of the VAT in metres (always 10 m)

                  TL = the length of the VAT in metres

An estimate of the number of HBTs within a particular area of vegetation was obtained by multiplying the VAT
derived average HBT density estimate for a surveyed area with an estimate of the extent (ha) of the broader
area supporting a similar type of vegetation type based on field observations and interpretation of high
resolution aerial photography.

Results

The HBT Survey Master Sheet and HBT Survey Sheets 01-05 provide details concerning:

         the location, species and extent of hollow development of individual HBTs identified during the
         individual HBT surveys;
         the locations of individual HBT transects;
         the location and extent of areas of vegetation associated with particular HBT transects for the purpose
         of deriving estimates of the density and number of HBTs; and
         a conceptual layout of development that was used to identify the locations where HBT loss is likely to
         occur.

Details concerning the densities and numbers of HBTs associated with different sectors of the Noosa on
Weyba site locality are also provided in the following tables.

         Table 1 - NoW Receive Land;
         Table 2 - NoW Send Land;
         Table 3 – External Roadways;
         Table 4 – Combined Totals for NoW Land and External Roadways; and
         Table 5 – Weyba Nature Refuge.

Tables 1-5 also provide details concerning the number of HBTs that would be lost and retained if the Noosa
on Weyba project was to proceed in the manner proposed.

An analysis and discussion of the HBT survey results and impact assessment is provided in Sections 4.2.2
and 5.4 of the Noosa on Weyba Ecological Assessment Report (Cardno 2013).

References

Keith R. Parker (1979). Density Estimation by Variable Area Transect.             Journal of Wildlife Management
43(2): 484-492

Richard M. Engeman, Ryan M. Nielson, Robert T. Sugihara (2005). Evaluation of optimized variable area
transect sampling using totally enumerated eld data sets. Environmetrics 2005; 16: 767–772. Published
online 9 June 2005 in Wiley InterScience (www.interscience.wiley.com). DOI: 10.1002/env.736

Solomon Z Obrowski and Shannon K. Murphy (2006). A practical look at the variable area transect.              Ecology,
87(7), 2006, pp. 1856–1860. The Ecological Society of America.




 I:\5101-19\wp\EAR\Background\HBT\Appendix C HBT Survey Method and Results.docx                 Page iii of iii

Used in these records

About this file

File size
32.0 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Attachment 7- Amended Ecological Assessment Report MCU12_208.pdf · 32.0 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.