Decision Notice - 010.2007.00001404.001 [As Published] · 142007.1404

NOOSA COUNCIL IDAS Development Application Decision Notice                                                  3 of 7




                                      Noosa Council Conditions
                                      INTEGRATED PLANNING ACT 1997, IDAS DEVELOPMENT APPLICATION


1.    Development undertaken in accordance with this approval must generally comply with the approved plans
      of development. The approved plans are numbered 07/114-1A and 07/114-2 prepared by John Norden
      and Associates and dated July 2007 and as may be amended by these conditions.

2.    Structures should be designed and constructed such that they are free standing within the waterway and
      are not connected to or behind the revetment wall.

3.    Jetties should have a level-walking surface of R.L 1.000 A.H.D or be level with the top of the revetment
      wall.

4.    A rigid handrail shall be fitted on one side of the walkway.

5.    No posts or vertical supports of the proposed jetty are to extend vertically from the structure unless they
      provide support for the handrail.

6.    No boatlifting devices are to be attached or moored at the jetty structure for the purpose of elevating a
      vessel above the water without Council approval.

7.    There shall be no electrical reticulation system carrying electricity in excess of 24 volts beyond the
      revetment wall.

8.    Lighting associated with the use shall be designed, installed, operated, and maintained in accordance
      with Section 3 of AS4282 Control of the Obtrusive Effects of Outdoor Lighting.

9.    Rock scour protection, wrapped in geotextile, extends 750 mm from the face of the revetment wall in this
      locality. Piles are to be located clear of this rock protection.

10.   The jetty is to be used for private purposes only with no commercial operations to be undertaken.

11.   Boat repair activities will not be permitted on site.

12.   Wastewater and sullage shall only be disposed of at approved pumpout facilities.

13.   The mooring facility shall not be utilised for live-aboard purposes.

14.   Any construction and post construction activity is not to impact on the condition of the waterway, and is to
      be conducted so as not to breach the Environmental Protection Act EPA (1994) and the Environmental
      Protection (Water) Policy 1997.

15.   The approval or conditions do not constitute a ruling on structural safety and the applicant must make
      their own arrangement to ensure adequacy of design and work. Also any approval granted does not
      warrant that such plans and specifications have been checked in detail, nor does not warrant that such
      plans and specifications have been checked in detail, nor does it absolve the owner of the land from
      complying with all the conditions of this approval and/or relevant Council By-Laws and Policies and/or
      relevant statues and/or statutory regulations in the execution and/or performance of said works. The
      Council does not accept any responsibility for the accuracy of such plans and specifications as approved.

16.   Certification by a Registered Professional Engineer of Queensland that states that the jetty is constructed
      in accordance with best practice methods and is structurally sound shall be submitted to Council prior to
      the return of any bond monies held by Council. A final inspection and approval of the structure by
      Council’s Inspector is also required prior to the return of any bond monies held by Council. Please
      contact Council’s Land Development Section to arrange the inspection.

17.   The jetty and boatlifting device shall be licensed with the Council upon completion of the structural work
      and shall be licensed annually thereafter.




AOP2 c:\docume~1\aop2\locals~1\temp\bcl technologies\easypdf 5\@bcl@7009a94e\@[email protected]