06/1168 - Change a Development Approval [As Published] · 132006.1168.02

Schedule A — Response or Change to Conditions

DA Item Description

No

but not limited to drainage structures, finished ground levels and
pavement surface levels. The data shall be submitted in the Asset
Design and As Constructed (ADAC) digital format. (Guidelines on the
use of ADAC are available at www.adac.com.au).

 

 

Approval of works shalt not be granted until all As Constructed
L | information has been supplied and accepted by Council.
Environmental Health
44 The developer must provide waste storage and disposal facilities in

accordance with Planning Scheme Policy No. 9 “Waste Management
Multi-Dweillings and Commercial and Industrial Premises”, including
an external imperviously paved area correctly sized for all refuse and
recycling containers and suitably screened from public places and
neighbouring properties. A bin wash area is required with a cold-
water tap, hose and drain outlet connected to sewer. The drain outlet
is to be designed to prevent storm water entry to the sewerage
system and this can be achieved with a nib wall 50mm high and up to
700mm x 700mm wide (max 0.5m}, or alternatively the waste area
can be roofed, or any other design approved by Council.

 

Response

Reference

PYadtelim eh

   

 

 

 

Waste storage and disposal facilities
will be provided in accordance with
Planning Scheme Policy No. 9 “Waste
Management Multi-Dwellings and
Commercial and Industrial Premises.

Details can be
provide in the
future when
detailed design of
the clubhouse has
been completed.

 

45

All bin wash areas in excess of 700mm Square are to be roofed and
the floor is to fall to a bucket trap with the waste pre-treated by a
grease arrestor prior to discharge to the sewer. The appropriate
backflow prevention devices are to be installed at the bin wash area.
Bunding set above 75mm is required to exclude excessive rain-water
entering these areas.

Requirements will be included in
detail design of clubhouse

 

46

 

A Trade Waste Application must be submitted prior to the issue of a
Development Permit for Building Works.

 

Noted

 

 

 

14