Original source · versioned page text
2016-09-06 - Planning & Environment Committee Agenda
Very large file: it may take a few minutes
The original of this document is very large (23.7 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Text sections have not been matched to the original PDF pages. Use the original document to check page numbers.
PLANNING & ENVIRONMENT COMMITTEE MEETING AGENDA 6 SEPTEMBER 2016
The development involves a number of built form and density relaxations, discussed below.
Population Density & Gross Floor Area
The proposal exceeds the population density by 1 person (about 2 bedrooms or 1%).
Discussions with the applicant suggest it is a rounding error in its calculation. The gross floor
area limit has been based erroneously on that population density and also slightly exceeds the
limit. Condition 4 is recommended to address these issues.
Height in metres
The buildings largely comply with the site’s 8m height limit but portions of roofs on the downslope
side of the four buildings at the rear of the site are higher. The plan extracts below show the
extent of roofs above 8m shaded grey.
Figure 11 – Height Relaxation Plan Extract
Page 25 of 118
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.