Installation Guide - Load Support _v2021.3a

Expand Neoloy Tough-Cell Sections

Expand Sections over Anchors
1.    Place the outer cells of the joined sections over the anchors on one side of the road.

2.    Open and expand the sections to the opposite side and “hook” over the anchors (stakes).

3.    Verify that the expanded sections are flush on the ground and opened to their nominal dimensions (see Figure and
      Table below).

      NOTE: Do not walk on empty cells as this may bend the cell walls and damage the system.
      Spread planks or boards over the empty cells to walk over the Neoloy Tough-Cell sections if necessary.




              FIGURE 13. CELL DIMENSIONS/DIRECTION

                                                                       FIGURE 14. EXPANDING SECTIONS OVER ANCHORS



                                 TABLE 2. NOMINAL DIMENSIONS OF CELLS & THEIR OPENING APERTURE

     CELL & SECTION NOMINAL DIMENSIONS
     CELL PROPERTIES    DESCRIPTION                              SECTION PROPERTIES         DESCRIPTION

     Cell Distance between        330 mm (±2.5%)                 No. of Cells/m2            40
     Weld Seams

     Cell Wall Heights            65, 75, 100, 120, 125, 150     Section Size (Expanded)    2.50 x 8.00 m (±3%)
                                  mm

     Cell Dimension (Expanded)    250 x 210 mm (±3%)             Section Area (Expanded)    20 m2




PRS-EN-TD-LS-3000                                              11/21                                              Ver. 2021.3