Council archive · source document
Approved Plans OPW18 0262 · OPW18/0262
Plans and drawings: the text below has words only, no drawings.
-
A Grade Buffalo 'Sir Walter' Turf to be
NOOSA COUNCIL laid with staggered close butted joints
APPROVED PLAN so that finished turf surface is flush
OPW18/0262 11 DEC 2018 100mm with adjacent surface levels.
Imported site topsoil laid to
minimum of 100mm depth. Organic
75mm turf starter fertiliser to be applied to
manufacturers recommendations
Lay artificial turf by Urban Turf
to top layer of topsoil prior to turf
Solutions 'Urban Everlawn'. Lay to
being laid.
manufacturers recommendations.
Pin fix and dress with sand as per Subsoil cultivated to 75mm deep and
150mm manufacturer. ensure free draining in preparation for
topsoil application.
150mm of compacted crusher
Base grade to falls. Notes: Following laying of turf, irrigate immediately
Subgrade free from organic until topsoil is moist to full depth. Continue irrigation regularly
matter and graded evenly. maintaining soil moisture until grass is fully established.
TYPICAL ARTIFICIAL TURF DETAIL TYPICAL A GRADE ‘BUFFALO’ TURF
3 4
1:5 @A3 1:5 @A3
FOOTPATH - DETAIL NOTES
50 x 50mm Hardwood Timber Stake. Stake
is no to penetrate rootball. Penetrate a
minimum of 200mm.
45L Tree (minimum) Refer to planting
Turf - Refer to detail
schedule for sizes and quantities.
100mm x 50mm Hardwood
timber edge. Fix to stake using 2 x Figure '8' Nylon Hessian Tie's stapled to
2 hot dipped galvanised 75mm nails 3m 2 x stakes as above.
per crossing.
Minimum of 800mm clear trunk.
100mm of 1inch Hoop Mulch
Topsoil refer garden bed detail 100mm of organic mulch as per garden bed
100mm detail. Maintain 50mm gap between mulch
and trunk.
75mm Tease rootball from container
prior to planting and loosen
roots where possible.
50 x 50 x 600mm Long hardwood
timber fixing stakes to be at 600mm H Backfill tree hole with
augmented site topsoil as per
ctrs. garden bed details.
Cultivated subgrade. + 200mm Apply slow release fertiliser to
base of tree rootball.
Existing subgrade.
3 x Rootball Dia
TYPICAL TIMBER EDGE DETAIL TYPICAL TREE DETAIL
5 6
1:10 @A3
This drawing is subject to
copyright, with all rights remaining
JOB: Landscape Design -
DATE: 12/09/2018 DESIGN: AL Materials, Legend and Landscape Details
to Createscapes Noosa. These 8 Attunga Heights
drawings should not be copied
without permission in anyway. JOB NAME: CSL028 CHECK: AL
All contractors are to confirm CLIENT: Tim McGary
CREATESCAPES NOOSA: measurements on site prior to SCALE: ISSUE: D
Abi Leybourne construction or planting. The
E: [email protected]
identification of existing services ADDRESS: 8 Attunga Heights, PAGE: 5 OF 5 PURPOSE: OPW
should also take place before
P: 0411 138 269
commencement of works.
Noosa Heads, 4567
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Approved Plans OPW18 0262.pdfRelated documentApplication case desk ↗
About this file
- File size
- 4.8 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.