Attachment 2 - Geotechnical Stability Assessment

Project No. PG-2096                                                                                                             Page | 7
May 2022
Ref: PG-2096, 2019-02-21, GR VER 4
Clare Design – Geotechnical Stability Assessment - Proposed Residence, 22 Arakoon Crescent, Sunshine Beach




value of 0.48 is recommended.                                 Higher values may be applicable with suitable
supervision.

If working stress methods are used in the pile design, the Rd,ug values given in Table 1
will need to be divided by a factor of safety of 2.5 to caluculate the maximum single
pile working load.

TABLE 1                ULTIMATE (UNFACTORED) PILE DESIGN PARAMETERS

                                                             Ultimate Unfactored End
                                                                     Bearing*                                Ultimate Unfactored Shaft
                     Material                                          (kPa)                                        Adhesion*
                                                                                                                       (kPa)
                                                                        >4D
               Very Loose to Loose                                      NR                                              NR
 Sands
               Medium Dense                                             900                                             30
 Notes:
 *Geotechnical strength reduction factor needs to be applied to these parameters.
 1. NR – Not Recommended.

Lateral Capacity

The lateral capacity of a pile is a function of many factors including the soil profile,
pile fixity and eccentricity, embedment length and other factors such as failure
mode, strength of the pile and the shear strength of the surrounding founding
materials.

Horizontal pile capacities will be provided by passive resistance from the weathered
rock strata. However, the capacity from the soils should be neglected, given their
potential for creep.

An assessment of a single pile's lateral capacity is provided by using Broms Charts as
shown in Figure 1. Refer to Table 2 for applicable parameters. Piles are usually
deemed to be classed as short when the L/B ratio is less than 10 to 12.




                       FIGURE 1                ULTIMATE LATERAL RESISTANCE OF PILES