Landscape Specification

CONTENTS


11.         WATERFEATURES & POOL FINISHES

11.1.       GENERAL SPECIFICATIONS
The pools and waterfeature described below are the design intent only. For detailed plans and specification
refer to pool and waterfeature engineer’s documentation.

Health and Safety
The system must be installed so that it can be completely flushed out and cleaned easily.

Acoustic
Consideration must be given to the pump and filtration system design so that no noise is evident other than
the water noise of the water feature during operation and that the existence of water hammer is prevented.

Joint Sealers
Supply and install approved joint sealers to all piping and sleeves at all penetrations.

Slip resistance
Ensure pavement finishes including sealers, tactiles and directional pavers are compliant with the slip
resistance requirements of the National Construction Code (NCC) and Australian Standards AS/NZS 4586
2013, AS HB 198 2014 and Star / Echo requirements for slip resistance.

Ramp surfaces must have a slip resistance classification as per BCA table D2.14.

Provide complying slip resistance test results to the Project Manager.

Samples
Install a minimum 5m2 for floor finishes and 2.5m long for edge types sample area of each different finishes
type showing materials, surface pattern, colour, finish and joints for approval by the Landscape Architect. If
acceptable, this sample should be retained as a quality benchmark and shall form part of the finished works.




URBIS
URB-SPC-LAN-P0025138 - IFC.DOCX                                                                        PAGE   38