Landscape Specification

                                                                                                        DRAPE CONCRETE BACKLESS BENCH SPECIFICATION

                                                                                               Suface Installation Detail
                                                                                               ○ Mark hole locations using MDF Templates (Supplied by S+G).
                                                                                               ○ Drill Ø40mm holes approx. 200mm deep into slab.
                                                                                               ○ Lay 20mm thick packers within product footprint (Supplied by Others).
                                                                                               ○ Wind M20 threaded rod into ferrules in underside of product (Supplied by S+G).
                                                                     20mm Packer               ○ Sling concrete module into place and chemically set (Epoxy Grout) rods into pre-drilled
                                                                                                   holes.
                                               450mm

                                                       430mm




                                                                     Foam Backing Rod
                                                                                               ○ Rest product on packers and remove slings.
                                                                                               ○ Line all edges with Foam Backing Rod and seal with Polyurethane Sealant, leaving a
                                                                                                   smooth even fillet (Supplied by Others).
                                                                     Polyurethane Sealant

                                                                     M20x200mm Threaded Rod

                                                                     Ø40mmx200mm Core Drill




                         Recommended on site Installation Detail

                         Installation Detail

                                                                                               Sub-Surface Installation Detail
                                                                                               ○ Mark hole locations using MDF Templates (Supplied by S+G).
                                                                                               ○ Drill Ø40mm holes approx. 200mm deep into slab.
                                                                                               ○ Lay 20mm thick packers within product footprint (Supplied by Others).
                                                                                               ○ Wind M20 threaded rod into ferrules in underside of product (Supplied by S+G).
                                                                                               ○ Sling concrete module into place and chemically set (Epoxy Grout) rods into pre-drilled
                                                                      20mm Packer
                                                                      Polyurethane Sealant
                                               450mm




                                                                                                   holes.
                                                                                               ○ Rest product on packers and remove slings .
                                                                                               ○ Line all edges with Foam Backing Rod and seal with Polyurethane Sealant, leaving a
                                                               FFL
                                                                      Foam Backing Rod
                                                                                                   smooth even fillet (Supplied by Others) up to Finished Floor Line (FFL).

                                                                      M20x200mm Threaded Rod

                                                                      Ø40mmx200mm Core Drill
© Street + Garden 2021




                         Recommended on site Installation Detail

                         Installation Detail