Council archive · source document
Geotechnical Report (1) · MCU21/0212
Very large file (10.7 MB): the original may take a few minutes to open or download. The page text below is quick to read.
PROPOSED RESIDENCE
66 SEAVIEW TERRACE, SUNSHINE BEACH
Table 5: Slope/W Analysis Results
Analysis Description Factor of Safety
Vertical cut into the toe of the dune caused by erosion scouring
Case 1 0.5
during a high sea event.
Lower slope failure following reprofiling of the slope due to
Case 2 0.9
failure/erosion from Case 1.
Retrogressive upper slope failure following reprofiling of the slope
Case 3 1.0
due to the Case 2 failure
Slope stability analysis following reprofiling of the slope from
Case 4 Case 1 to Case 3, with the eastern property boundary protected 1.5
by a micro-piled (or similar) wall.
Slope stability analysis following reprofiling of the slope from Case
Case 5 1 to Case 3, with the eastern edge of the residence protected by a 1.6
micro-piled (or similar) wall.
Results of the analyses indicates the following:
Case 1 – The assessed FOS of 0.4, being much less than 1.0, indicates a slope failure. A vertical
erosion cut would lead to retrogressive failures moving up slope, primarily within the very loose to
medium dense sands. The nature of the failures will be dependent on numerous factors such as
surface soil stabilisation provided by vegetation and local variations in subsurface conditions (e.g.
indurated sand zones), however the modelled slip surface is consistent with previous experience in
similar conditions.
Case 2 – The FOS of 0.9 indicates that further slope failure is likely following reprofiling of the slope
due to erosion/failure from Case 1.
Case 3 – Following reprofiling of the slope from retrogressive translational failure(s), further instability
of the slope extending under the eastern property boundary is likely to occur based on the calculated
FOS of about 1.0.
Case 4 – If the eastern boundary is protected by an engineer designed and certified micro-pile (or
similar) structure the potential critical slip surface takes the form of a deep-seated failure into the
underlying medium dense (or denser) sands. Such a failure results in a FOS of 1.5 or greater, even
following a vertical erosion cut and reprofiled slope from Cases 1 to 3.
Case 5 – If the eastern edge of the proposed residence is protected by an engineer designed and
certified micro-piled (or similar) wall structure the potential critical slip surface also takes the form of a
deep-seated failure into the underlying medium dense and/or dense (or denser) sands. Such a failure
also results in a FOS of 1.5 or greater, including allowance for a vertical erosion cut and reprofiled
slope from Cases 1 to 3.
23 November 2021
Report No. 21370-001-Rev0 14
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Geotechnical Report (1).pdfRelated documentApplication case desk ↗
About this file
- File size
- 10.7 MB (very large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.