Council archive · source document
Att 4 - Code Compliance · MCU17/0020
Attached to the e-mail Development application - Aquaculture MCU17/0020.
Column 1 Column 2 Column 3
Specific Outcomes Probable solutions (if code Assessment
assessable)
S11.2 The design and siting of all generation of mechanical
mechanical equipment, including noise, odour and the likelihood
fans, pneumatic feed systems and of off-site vibration, so as not to
other equipment, minimises the cause unlawful environmental
generation of mechanical noise, nuisance.
odour and the likelihood of off-site
vibration.
S11.3 For breeding or boarding
kennels—the kennels are
constructed of brick, concrete or
masonry
O12 The design and S12.1 Buildings used to house Complies - All waste water,
operation of the animal animals, as well as waste storage including water used to clean
use incorporates areas, are located on land that is the tanks between breeding
integrated water not subject to flooding by the 100 cycles, will be managed by
management elements year ARI event; AND S12.2 The locating grates around the
such that a) stormwater base of all sheds is elevated above impervious surfaces and sen to
is prevented from natural ground level to ensure that the Unitywater sewer network.
entering sheds and stormwater run-off does not enter This will ensure contaminants
waste storage areas; b) the sheds. AND S12.3 All waste will not reach nearby
stormwater peak water, including water used to waterways.
discharges and run-off clean animal sheds, is managed
volumes are not so that contaminants will not reach
increased; and c) natural nearby waterways.
drainage lines and
hydrological regimes are
maintained as far as
practicable.
O13 Water is managed S13.1 & S14.1 Aquaculture occurs Complies – The tanks are all
on site such that it will in tanks or ponds where water is connected in a closed loop
not reach Queensland fully reticulated within the facility system to Unitywater’s sewer
waters via overland or with no discharge property or networks so there is no
stormwater flows. AND waterways. discharge to nearby
O14 Development is waterways.
located and designed to S13.2 & S14.2 Tanks or ponds
avoid, or otherwise used to cultivate aquaculture The site is not affected by
minimise, impacts to fisheries resources or for treatment flooding.
areas host to fisheries or settlement of water are
resources. AND constructed with the lowest point of
O15 Tanks or ponds are the top of wall at least the height of
designed to avoid the Q50 flood level.
leakage.
S15.1 Ponds are designed and As per the aquaculture
constructed in accordance with approval for MCU14/0096, the
Department of Agriculture, proposal ponds will be
Fisheries and Forestry's policy designed and constructed in
Guidelines for Constructing and accordance with Department of
Maintaining Aquaculture Agriculture, Fisheries and
Containment Structures. Forestry's policy Guidelines for
Constructing and Maintaining
Aquaculture Containment
Structures.
O16 The use is No solution provided Complies – The use will be
conducted in a manner conducted as a closed system
that minimises risk of which minimizes any risk of
environmental harm3 . environmental harm.
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Att 4 - Code Compliance.pdfRelated documentApplication case desk ↗
About this file
- File size
- 408 KB (small file)
- File type
No other editions are linked here.