Council archive · source document
Referral Agency Response Minor Change RAP18-0037.01 · RAP18/0037.01
Officer: Lisa Pienaar Direct Telephone: 07 53296514 Our Reference: RAP18/0037.01 : JELDER Your Reference: n/a 17 April 2019 Coastal Building Certifications Pty Ltd PO Box 890 BUDERIM QLD 4556 [email protected] Dear Sir/Madam, Referral Agency Response – Minor Change Planning Act 2016 I refer to your application received on 9 April 2019, requesting a minor change to an existing development approval. Council, as a concurrence agency, decided your requested changes. Details are as follows: application details Application No. RAP18/0037.01 Street Address: 53 Mossman Ct Noosa Heads Qld 4567 Real Property Description: Lot 91 N 21847 Planning Scheme: The Noosa Plan (8 June 2018) Decision details The following type of approval was issued on 6 November 2018. Development Permit for Building Works (Detached House) In relation to the request to make a minor change to the existing approval, Council on 17 April 2019, decided to approve the requested changes. The changes are detailed below: A. Approve the change. B. Amend conditions 2, 5 & 6. concurrence agency conditions When Conditions must be Complied With Unless otherwise stated, all conditions of this Decision Notice must be complied with prior to the use commencing, and then compliance maintained at all times while the use continues. Approved Plans Development undertaken in accordance with this approval must generally comply with the approved plans of development. The approved plans are listed in the following table unless otherwise amended by these conditions. Plan No. Plan/Document Name Date SP1.0 Site Plan, drawn by Chris Clout Design 26/02/19 C0.0 Lower Floor Plan, drawn by Chris Clout Design 22/06/18 WD2.0 Ground Floor Plan, drawn by Chris Clout Design 26/02/19 WD3.0 Upper Floor Plan, drawn by Chris Clout Design 26/02/19 C3.0 Elevations (North and South), drawn by Chris Clout Design 22/06/18 C3.5 Elevations (East and West) drawn by Chris Clout Design 22/06/18 C4.0 Section, drawn by Chris Clout Design 22/06/18 Building Height The maximum height of the development must not exceed 8.0 metres above the natural ground surface with the exception a small section of pitched roofline as shown on Plan no. C3.5 to be a maximum height of 8.153m from natural ground level. Certification must be submitted to Council from a Licensed Surveyor which certifies that the building does not exceed the maximum height requirement of this Decision Notice. Terrace/Roof deck The pavilion wall must be partially setback a minimum of 1.0 metre from the eastern boundary in accordance with the approved plans and not be a height greater than 3 metres. The roof deck and associated balustrading must be setback a minimum of 1.5 metres on the eastern boundary and the area between the balustrading and edge of structure is to be densely landscaped. Fencing and Walls Any street fencing must be set back an average of 1 metre from the front property boundary. Any fencing on the front boundary must either: not exceed a maximum height of 1.2m; or be of open construction. The area of land between the fence and the front property boundary must be densely landscaped to screen any fencing from the street. Landscaping A minimum of 20% of the site must consist of soft landscaping. Earthworks and Retaining Walls and Geotechnical Stability A Registered Professional Engineer Queensland shall supervise the excavation of the site and the construction of the new works to determine whether any additional measures are required to protect the stability of adjoining buildings and/or structures and/or services and/or lands. Certification of the completed works must be provided to Council by the supervising engineer. The certification shall state that the completed works conform with all aspects of the design and that the completed works will not have any adverse effects on the stability of adjoining buildings and/or structures and/or services and/or lands. The use of vibratory equipment of any kind is not permitted to be used (including vibrating rollers and the use of vibrating installation techniques for sheet piling and other construction vibrations caused by excavating, earthmoving or demolition machinery or other similar construction techniques) unless approved and supervised by a Certified Geotechnical Engineer. Under such circumstances the operator of such equipment shall at all times comply with the directions of the Geotechnical engineer and the reasonable and lawful directions of Council officers. All earthworks must be contained entirely within the subject site unless written permission from the respective landowner(s) is provided to Council. All earthworks must be undertaken in accordance with the provisions of Australian Standard AS3798: Guidelines on Earthworks for Commercial and Residential Developments. Stormwater Drainage Stormwater runoff must not be directed on to any adjoining property or cause the additional ponding of water on any adjoining lands or the blockage of, or interference with, any natural watercourses Stormwater runoff from the development to be disposed of on-site must not cause scour or damage to the subject site or any adjoining property. Damage to Services and Assets Any damage caused to existing services and assets as a result of the development works must be repaired at no cost to the asset owner at the following times: where the damage would cause a hazard to pedestrian or vehicle safety, immediately; or where otherwise, upon completion of the works associated with the development. Any repair work which proposes to alter the alignment or level of existing services and assets must first be referred to the relevant service authority for approval Advisory notes The following notes are included for guidance and information purposes only and do not form part of the assessment manager conditions: The planning scheme declares Operational Work for the construction of a driveway and vehicle crossover to the property to be self-assessable against the Detached House Driveways Code. A self-assessable application is required to be submitted to Council for the vehicle crossover (*link below) OR if the proposed driveway and vehicle crossover does not comply with each Acceptable Solution contained in the Code, a Development Permit for the work is required to be obtained from Council. *http://www.noosa.qld.gov.au/documents/40217326/40415739/Vehicle%20Crossover%20Application%20Pack.pdf reasons for inclusion of conditions The proposal is subject to specific built form parameters outlined in The Noosa Plan. representations about referral agency response The applicant may make representations to Council about this referral agency response at any time before the application is decided pursuant to section 30 of the Development Assessment Rules. Yours faithfully, Lisa Pienaar Development Planner Enc: Approved Plans/Documents [word/footer2.xml] Page 4 of 4 [word/footer3.xml] PO Box 141 P. (07) 5329 6500 [email protected] TEWANTIN QLD 4565 F. (07) 5329 6501 www.noosa.qld.gov.au Page 1 of 4 [word/header1.xml] 3
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Referral Agency Response Minor Change RAP18-0037.01.docxRelated documentApplication case desk ↗
About this file
- File size
- 76 KB (small file)
- File type
- DOCX
No other editions are linked here.