01072015144724 · MCU10/2065

MCU10/2065

PLANNING

4.

General

Development undertaken in accordance with this approval must generally comply with
the approved plans of development. The approved plans are listed in the following _
table and as amended by these conditions:

 

 
 
 
   

 

  

an Na Q
Site Plan Level 1, prepared by EPS Design 14/07/11

 

 

Site Plan Level 2, prepared by EPS Design 44/07/11

 

“Level 1, prepared by EPS Design 14/07/11

 

Level 2, prepared byEPS Design =—S«14/07/11

 

 

Southeast & Northeast Elevations, prepared | 14/07/11
by EPS Design
. Northwest & Southwest Elevations, prepared | 14/07/11

06 by EPS Design i

The development must be undertaken and operated in a manner that causes no
detrimental effect upon the amenity of the neighbourhood by reason of the creation of
excessive noise, lighting nuisance or other emissions.

The requirements of this development approval are to be effected, prior to the use of
the premises. Council reserves the right to call upon the bond or guaranteed sum
referred to in this approval to effect compliance with conditions.

The developer. must obtain all of the other Development Permits referred to in the _
Decision Notice, prior to obtaining a Development Permit for Building Works.

 

 

 

 

 

 

 

Security Bond

5.

Security in the form of a cash bond or trading bank guarantee to the sum of $10,000
must be submitted, to secure performance of all conditions of this approval, prior to the
issue of a Development Permit for Operational Works. The cash bond or trading bank
guarantee will be returned on performance of the conditions of approval less any costs

.-incurred-by-Council-in respect of enforcing performance. ofthis permit...

The requirements of this development approval are to be effected, prior to the use of
the premises. Council reserves the right to call upon the bond or guaranteed sum
referred to in this approval to effect compliance with conditions.

Building Design

7.

The building height of the development shall.not exceed 8m above the natural or

“finished ground level, whichever is higher, at any one point. -

The garage wall must be setback a minimum 200mm from the southeast boundary and
either:-

8.1. provided with battens as indicated on the approved plans which comply with
part 3.7.1 - Fire Separation of the National Construction Code; or

8.2. provided with an alternate fagade treatment that is approved by the
assessment manager prior to the premises being occupied; and

8.3. A fence shall be constructed along the boundary line, in front of the garage.

PD-DA-FM384/1-13/04/2010 Page 2 of 13