Skip to the record
Accept no substitutions.

Council archive · source document

Referenced Document - MCU13/0146

of 31

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Report #S7186, Lot 10 (MCH 5387), Tropicana Rise, Castaways Beach QLD 4567
28 August 2013




 3.0       ASSESSMENT RESULTS

 3.1       Desktop Study

        3.1.1       The Proposed Development
It is proposed to construct a highset two storey residence with the following construction parameters:
      Metal sheet roof
      Floors between levels to be a mixture of suspended timber and slab on ground concrete
      Lightweight external wall cladding and reinforced block walls
    Suspended floors supported on timber and/or steel posts
The residence has been designed to step down the slope to minimise earthworks.

        3.1.2  Historical Landslide Data
A search of The Noosa Plan (SCRC 2000) indicates the allotment is located in an area of “known” landslip
hazard, as presented in APPENDIX B.

        3.1.3       Use and Limitations of Zoning
Landslide risk zonings at district scale should be considered only the first step and not the final tool in
decision making for landslip-prone areas. It must be thoroughly understood that the zones established do
not include only land of the same stability, as it is impossible at this scale to show all individual unstable
or suspect areas specifically. Instead, the zones depict land where a similar range of stability conditions is
present. As the boundaries between zones are generally approximate and in places gradational, it should
not be implied that they can signify that land on one side is stable and the other unstable. In such
boundary situations, general caution and further study on the ground is the appropriate course of action.

        3.1.4       Regional Geology
Geological records (Dept. of Mines and Energy 1999) indicate the site to be upon Quaternary Dunes
(mainly parabolic) that consist of quartz sand. The major dune systems evident today are resultant from
wind action. The dune systems extend westward and historically as sea levels rose the coastline moved
westward as sands were initially deposited by wave action. As sea levels declined wind action blew the
sands in a westward direction. Typically a sandy beach in its accreted state consists of a “beach berm”, a
well grassed/vegetated “incipient dune”, a high “frontal dune” and “hind dunes”. All these topographic
and geomorphic features can be seen in the surrounding areas.

        3.1.5       Engineering Characteristics of Geological Units
The behaviour of dune sands is almost wholly frictional with little if any cohesive effect. Particle grading,
size, angularity and insitu density all influence the load carrying capacity or sand strengths. Moisture
content is an important factor, especially during construction, as sands dry out any escarpment or flank
will tend to fail by slumping back to the “angle of repose”, which approximates 1:5 (V:H) or 20% or 11.5°.




GeoConsulting Pty Ltd
1/8 Denna St, Maroochydore, QLD, 4558. Phone: 5443 6622, Fax: 5479 1899, Email: [email protected]   3|Page

Used in these records

About this file

File size
2.7 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

REFERENCED DOCUMENT - MCU13_0146.pdf · 2.7 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.