6. Noosa River DMP Ver0 (Combined)

Page                        : 2 of 54
Work Order                  : EB2201963
Client                      : BMT COMMERCIAL AUSTRALIA PTY LTD
Project                     : A10342 - Noosa SAP

General Comments
The analytical procedures used by ALS have been developed from established internationally recognised procedures such as those published by the USEPA, APHA, AS and NEPM.                                   In house developed procedures
are fully validated and are often at the client request.
Where moisture determination has been performed, results are reported on a dry weight basis.
Where a reported less than (<) result is higher than the LOR, this may be due to primary sample extract/digestate dilution and/or insufficient sample for analysis.

Where the LOR of a reported result differs from standard LOR, this may be due to high moisture content, insufficient sample (reduced weight employed) or matrix interference.

When sampling time information is not provided by the client, sampling dates are shown without a time component. In these instances, the time component has been assumed by the laboratory for processing
purposes.
Where a result is required to meet compliance limits the associated uncertainty must be considered. Refer to the ALS Contact for details.

Key :          CAS Number = CAS registry number from database maintained by Chemical Abstracts Services. The Chemical Abstracts Service is a division of the American Chemical Society.
               LOR = Limit of reporting
               ^ = This result is computed from individual analyte detections at or above the level of reporting
               ø = ALS is not NATA accredited for these tests.
               ~ = Indicates an estimated value.
l   EP080 TRH Volatile/BTEX: Sample EB2201885_006 shows poor matrix spike recovery due to matrix interference. Confirmed by re-extraction and re-analysis.
l   EP080: Where reported, Total Xylenes is the sum of the reported concentrations of m&p-Xylene and o-Xylene at or above the LOR.
l   ASS: EA033 (CRS Suite):Retained Acidity not required because pH KCl greater than or equal to 4.5
l   EK061G (Total Kjeldahl Nitrogen as N): Sample EB2201290_001 shows poor duplicate results due to sample heterogeneity. Confirmed by visual inspection.
l   ASS: EA033 (CRS Suite): Laboratory determinations of ANC needs to be corroborated by effectiveness of the measured ANC in relation to incubation ANC. Unless corroborated, the results of ANC testing should
    be discounted when determining Net Acidity for comparison with action criteria, or for the determination of the acidity hazard and required liming amounts.
l   ASS: EA033 (CRS Suite): Liming rate is calculated and reported on a dry weight basis assuming use of fine agricultural lime (CaCO3) and using a safety factor of 1.5 to allow for non-homogeneous mixing and
    poor reactivity of lime. For conversion of Liming Rate from 'kg/t dry weight' to 'kg/m3 in-situ soil', multiply 'reported results' x 'wet bulk density of soil in t/m3'.
l   ASS: EA003 (NATA Field and F(ox) screening): pH F(ox) Reaction Rate: 1 - Slight; 2 - Moderate; 3 - Strong; 4 - Extreme