DA Form 1, Plans, Form 15, Council Breach Letter · OPW22/0076

 

Version 3— March 2013

Form 15—Compliance Certificate for building Design or Specification

 

 

 

 

 

 

 

 

 

 

 

 

NOTE This is to be used for the purposes of section 10 of the Building Act 1975 andlor section 46 of the
Building Regulation 2006.
RESTRICTION: A building certifier (class B) can only give a compliance certificate about whether
building work complies with the BCA or a provision of the QDC. A building certifier (Class B) can
not give a certificate regarding QDC boundary clearance and site cover provisions.

1, Property description Street address include no., street, suburb / locality & postcode)

This section need only be completed if ‘generic’

details of street address and property

description are applicable. Postcode

on case of (standarigenen) | Lot 8 plan details (attach ist if necessary)

patio and carport systems this section

may tbe eppieae: in which local government area is the land situated?

The description must identify all land the ‘generic’

subject of the application.

The lot & plan details (eg. SP / RP) are

shown on title documents or a rates notice.

If the plan is not registered by title, provide

previous lot and plan details,

2. Description of component!s certified

Clearly describe the extent of work covered by
this certificate, e.g. all structural aspects of the
steel roof beams.

 

‘FLOATBRICKS’ POLYETHYLENE (basic) FLOAT MODULE

 

(500mm x 500mm x 400mm) and ANCILLARY CONNECTIONS

 

when used in specific configurations as determined by the Designer:

 

- minimum 5 modules wide (2500mm o’all) per length / run when

 

unpiered

 

- minimum 4 modules wide (2000mm o’all) per length / run when

 

suitably (mooring) piered

 

3. Basis of certification

Detail the basis for giving the certificate and the
extent to which tests, specifications, rules,
Standards, codes of practice and other
publications, were relied upon.

 

AS1170.1, AS1170.2, AS3962 (part), AS4997

 

BUILDING CODE OF AUSTRALIA (part)

 

 

Max loading: 1.8Kn point [email protected] wall thickness / 2.7 kPa

 

@ freeboard ~ 100mm in salt water

 

 

4, Reference documentation
Ciearly identify any relevant documentation,
@.9. numbered structural engineering plans.

 

- DOCKPRO (Australia) design specifications

 

 

- SRB Consulting Engineers performance testing calculations

= a a7 =

 

 

 

LOCAL GOVERNMENT USE ONLY

The Building Act 1975 is administered by the
Department of Housing and Public Works

Queensland
Government