Council archive · source document
Decision Notice - Approved by Delegation of Authority - DBW26 0014 (As Published) · DBW26/0014
Currency Period
2. This development approval lapses if the works have not substantially started by 8 April 2028,
unless an application to extend the currency period is approved by Council.
Approved Plans
3. Development authorised by this approval must be undertaken generally in accordance with
the Approved Plans listed in the table below.
Plan No. Rev. Plan/Document Name Date
2515_ DA 001-2 2 Site Plan 24/03/2026
2515_ DA 100-2 2 Ground Demolition Plan 24/03/2026
2515_ DA 101-2 2 Proposed Ground Floor Plan 24/03/2026
2515_ DA 102-2 2 First Demolition Plan 24/03/2026
2515_ DA 103-2 2 Proposed First Floor Plan 24/03/2026
2515_ DA 200-2 2 Section 24/03/2026
2515_ DA 300-2 2 Elevations 1 24/03/2026
2515_ DA 301-2 2 Elevations 2 24/03/2026
Damage to Services and Assets
4. Any damage caused to existing services and assets as a result of the development works
must be repaired at no cost to the asset owner at the following times:
a. where the damage would cause a hazard to pedestrian or vehicle safety, immediately;
or
b. where otherwise, upon completion of the works associated with the development.
Any repair work which proposes to alter the alignment or level of existing services and assets
must first be referred to the relevant service authority for approval.
Coastal Protection
5. All lighting must be positioned and managed to reduce sky glow and light spill onto the beach
to minimise disruption to turtle nesting and sea-finding behaviour of hatchlings. The following
must be undertaken:
a. All windows, glass doors, glass panels and sky lights facing the beach (NE, E, SE)
must have 15% visible light transmittance tinting.
b. All windows, glass doors, glass panels and sky lights facing the beach (NE, E, SE)
must be fitted with opaque blinds, to be drawn from 8pm during turtle nesting and
hatching season (October – May).
c. All outdoor lights must have a maximum of 2700 K correlated colour temperature
(CCT). All indoor lights must have a maximum of 3000 K CCT. All lighting (interior and
exterior) must avoid the use of halogen, metal halide, or fluorescent lights.
d. Amber LED (590-610 nm) or low pressure sodium lighting must be used as a standard.
Warm white is to be used only where colour rendition is required. LED lights must not
contain short wavelength blue light and supplier should be asked to provide spectral
power curve of requested LEDs to prove the absence of short wavelengths.
e. The number and wattage of lights must be minimised.
Page 2 of 5
Document Set ID: 24766576
Version: 2, Version Date: 14/05/2026
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Decision Notice - Approved by Delegation of Authority - DBW26 0014 (As Published).pdfRelated documentApplication case desk ↗
About this file
- File size
- 147 KB (small file)
- File type
No other editions are linked here.