06/2361 - Response to information request issued 21/11/06 [As Published] · 132006.2361

 
      
  
    
     

Minumum 900
clearance

VENICLE TURNTADLES
cone: FLECTHOOD

Electrical outlet
adjacent to motor

 

  

Minumum 906
_ clearance
2 +

e SPECIFICATIONS FOR THE
| INSTALLATION OF A
VEHICLE TURNTABLE

TURNTABLE SUPPORT SLAB REQUIREMENTS:

 

 

The turntable supporting slab, to be provided by others, 2. The turntable, including the stationary edge
shall including the fotlowing, as detailed: protection angle, drive motor cover, and
controls are supplied, installed and secured in
1. Capacity to support the turntable loadings as position by vehicle turntables.
detailed. 3. The infill concrete to encase the turntable
2. A turntable recess 135mm deep at the turntable edge angle is poured by others, with all
edge with additional falls to the motor pit. reinforcement requirements to the client’s |
The recess shall be oversized beyond the turntable engineering specification. e@ @
perimeter by 290mm minimum all round. The .
recess shape need not be round if preferred. TURNTABLE LOADINGS: 1

Design loadings to be applied to supporting slabs. i

3. Am i includi drainage
otor pit 250mm deep including a nag (Slab design by the client’s structural engineer).

outlet. A three phase power supply and isolation
switch shall be provided to the turntable control . !
location, preferably on a wall face within 5000mm Total Turntable Loan ‘ \
of the turntable. A 25mm diameter conduit and Total turntable self weight: 12.2kN ‘

draw wire shall be provided between the control Maximum applied live load 48.0kN .
location and the motor pit. (including impact allowance)

1 May 1998
The motor pit should be located in an area of low Central Bearing:
traffic movement. Where turntables are to be Turntable self weight: 4.0kN
installed out of tevel the motor pit shal! be located Maximum applied live toad: 24.8kN

on the low side.

Perimeter support:

 

INSTALLATION PROCEDU RE: . Turntable self weight: 8.2kN i The information and drawings contained within this leaflet are copyright and may not be used without
1. The supporting slab, with recesses as detailed shall (uniformly distributed to perimeter) i the prior written consent of Vehicle Turntables

be provided by others, including power supply and Maximum applied live load: 15.0kN :

conduit to the motor pit. to a perimeter support roller ‘

69 Melbourne Street, Riverstone NSW 2765 * PO Box 141 Kellyville NSW 2155

Ive equally spaced t roll
(twelve equally spaced support rollers) Telephone 1800 689 890

NOTE: Concreters should contact Vehicle Turntables prior to commencing work as an aid to good coordination