Original source · versioned page text
2020-07-16 SM Agenda - Item 1 - Attachment 3 - Final Noosa Plan 2020 Part 4-6
Plans and drawings
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawn Performance outcomes Acceptable Outcomes
(e) provide a feeling of enclosure and human scale for adjoining properties which share the same frontage;
pedestrians so as to contribute to the “sense of place”; and (e) where falling towards the street, are no less than 2.5
(f) have an adequate clearance distance from the kerb to metres at their lowest point or where cantilevered, are no
prevent obstruction. less than 2.7 metres at their lowest point;
(f) use an awning slope of within 15 degrees of adjacent
awnings;
(g) are no more than 500 millimetres higher or lower than
adjacent awnings within 2 metres away; and
(h) are no higher than 3 metres in height.
Editor's note—refer to figure 6.4.2.5 for design outcomes for
awnings
Car parking and access
PO23 AO23.1
Pedestrian safety and convenience are not threatened or reduced Car parking is not located forward of the front building line or from
by additional vehicular driveways. building setback.
AO23.2
Provision is made for shared driveways to minimise the number
of driveways interrupting the flow of pedestrians along the
footpath.
Editor's note—refer to figure AP311A for design outcomes for
shared driveways.
Basements
PO24 AO24
Basement design: Basements are limited to one access a maximum of 6 metres
(a) does not dominate the street or building design; wide.
(b) visually integrates with the building;
Editor's note—refer to figure 6.9.2
(c) screened through landscaping; and
(d) does not present as a storey to the street.
Mechanical plant, equipment and storage
PO25 AO25.1
Mechanical plant and equipment (including air conditioning Mechanical plant, refuse and recycling area, vents and exhausts
equipment) and storage areas are designed and located to: are not visible from a street, public space or adjoining residential
(a) avoid adverse visual impacts when viewed from the street use and is acoustically screened from adjoining sensitive land
and adjoining properties; and uses.
(b) visually integrate with the building design.
AO25.2
Mechanical plant and equipment are:
(a) located more than 2 metres from any property boundary;
(b) where located at ground level, screened by fencing 1.5
metres in height or dense vegetation of at least 1.5 metres
in width incorporating grouped trees and shrubs with a
maximum separation distance of 1 metre measured from
the centre of the tree or shrub;
(c) are visually integrated into the line and plane of the building
and roof design and do not project beyond the height or
width of the building when viewed from the street and
adjoining properties; and
(d) fully enclosed or screened where above ground level such
that they are not visible from the street frontages nor
adjoining properties.
NOOSA PLAN 2020 Page 60 of 67
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
Large file: the download may take up to a minute.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.