Skip to the record
NoosaWatch™: The source of truth.

Original source · versioned page text

SUPERSEDED - Approved Decision Notice - MCU25 0079 [As Published]

of 16

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

2508-47661 SRA

Attachment 1—Referral agency conditions

(Under chapter 3, part 3, division 1, section 56(1}(b){i) of the Planning Act 2016 the following conditions must be
attached to any development approval relating to this application)

 

 

No. | Conditions Condition timing
Development Permit: Material change of use

 

 

10.4.3.1.1 — Contaminated land (unexploded ordnance) —The chief executive administering the
Planning Act 2016 nominates the Director-General of the Department of State Development,
Infrastructure and Planning to be the enforcement authority for the development to which this
development approval relates for the administration and enforcement of any matter relating to the
following condition:

 

1. Provide certification to the Department of State Development, Prior to the
Infrastructure and Planning at [email protected] | commencement of
by an approved contractor on the Australian Government, works
Department of Defence, Unexploded Ordnance (UXO) Panel that
the:

(a) subject site has been remediated and cleared of unexploded

ordnances; or
(b) proposed use can be suitably managed on the site.

 

 

 

 

 

State Assessment and Referral Agency Page 3 of 5

Document Set ID: 24381517 Page 13 of 16
Version: 4, Version Date: 17/12/2025
Log in to download the original file

SUPERSEDED - Approved Decision Notice - MCU25 0079 [As Published].pdf · 513 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.