RFI - Att 3 - EZGREY Manual

Maintenance

To retain the original reliability and performance of the EZGREY System
the following maintenance procedure should be followed. Please ensure
that you wash your hands thoroughly after contact with Greywater or
handling any part of the EZGREY System.

The following maintenance steps should be carried every 3

months and not less than once every 6 months:

- Open top cover of the EZGREY tank

- Remove primary sponge filters and wash thoroughly in a bucket, with a
garden hose or in any basin not connected to the dedicated Greywater
line

- Re-insert the filter in its original position, close the lid of the tank
and the EZGREY System is ready to operate again.

The following maintenance steps should be carried out once a

ear:

» Open top cover of the EZGREY tank

- Remove the primary sponge filters and wash thoroughly in a bucket,
with a garden hose or in any basin not connected to the dedicated Grey
water line.

- Wash thoroughly the tank with a garden hose and drain the tank using
the pump to discharge to a sewer outlet (the irrigation system should be
disconnected during this process)

- Disconnect the EZGREY pump and connect the supplied going away
backup quick connector.

- Flush the Grey Flow emitters with fresh water for about five minutes.

- Re-insert the filter, reconnect the pump, close the lid of the
EZGREY tank and the EZGREY system is ready to operate again.

- Top up mulch over the Grey Flow emitters to a minimum depth of
100mm.