Concurrence Agency Response - DERM · OPW11/0409

                                                          DERM Permit number: SPCC03748912


CONDITIONS

Agency Interest - General
1.     All works are to be constructed in accordance with the attached approved drawings and specifications
       listed in the approved plans section in the notice attached to this permit.
2.     All materials and works must comply with Australian Standards.
3.     An appropriate spill kit, personal protective equipment and relevant operator instructions/emergency
       procedure guides for the management of fuel and chemicals associated with the operational works stage
       must be kept on site.
4.     Anyone working under this approval must be trained in the use of the spill kit.
5.     Telephone the Department of Environment and Resource Management's (DERM) Pollution Hotline on
        1300 130 372 or local office on (07) 5459 6132 immediately after becoming aware of any release of
       contaminants or other breach of condition, not in accordance with the conditions of this approval.
6.     The construction and installation of the works must not result in any adverse impacts on the surrounding
       environment, nor cause any long-term maintenance and management implications.
7.      Should the works result in adverse impacts, the permit holder is responsible for rectification works and
       where necessary the removal of the works causing impacts.
8.     The chief executive administering the Coastal Protection and Management Act 1995 may order the works
       to be removed or modified within a reasonable time, if the works have or are likely to have a significant
       effect on coastal management because the works:
       (i)    create a-danger to the public; or
       (ii)   cause erosion or land degradation; or
       (iii) are unstable; or
       (iv) have not been constructed according to the approved plans.

Agency Interest - Land
9.     No sand is to be removed from the coastal dune system or active beach system within the erosion prone
       area or coastal management district.
10.    Spoil removed from within the proposed development area must be stockpiled separately upon
       excavation, and reused, rather than disposed of.
11.    Best practice erosion and sediment control measures must be implemented and maintained to minimise
       erosion and the release of sediment.

Agency Interest - Acid Sulfate Soil
12.    Acid sulfate soils must be managed such that contaminants are not directly or indirectly released to any
       land or waters.
13.    Should acid sulfate soils be discovered they must be treated and managed inline with the latest edition of
       the Queensland EPA's 'Instructions for the Treatment and Management of Acid Sulfate Soils' 2001.

Agency Interest - Vegetation
14.    All works must be undertaken in a manner that minimises damage to the native vegetation on and
       adjacent to the site.
15.    There must be no death or permanent removal of marine plants, inter-tidal plants or native terrestrial
       woody vegetation outside of the disturbance footprint as indicated within the attached approved plans, as
       a result of these works.
16.    Following the operational works, disturbed areas on or adjacent to the site and the areas indicated in the
       approved plans must be revegetated with endemic native plants common to the site or if a modified area
       such as a park, using common turf or ground cover species.
17.    Revegetated areas (other than grassed areas) must be fenced off to prevent pedestrian and vehicular
       access.


Page 3 of 8 ' 091217                                              Department of Environment and Resource Management