Decision Notice - RAL23 0009 [As Published] · RAL23/0009

                      Currency Period
               2.     This development approval lapses if the requirements of the conditions have not been
                      completed and an application for plan seal is not lodged with Council by 22 September 2027
                      unless an application to extend the currency period is approved by Council.
                      Approved Plans
               3.     Development undertaken in accordance with this approval must generally comply with the
                      approved plans of development. The approved plans are listed in the following table unless
                      otherwise amended by these conditions.

                        Plan No.              Rev.    Plan/Document Name                               Date

                        Sheet 1 of 1          G       13329-PRO-01                                     15/08/23

               4.     All lot numbering on the subdivision plan to be submitted to Council for compliance
                      assessment must remain as shown on the Approved Plans.
               5.     The development must be undertaken and operated in a manner that causes no detrimental
                      effect upon the amenity of the neighbourhood by reason of the creation of excessive noise,
                      lighting nuisance or other emissions.
                      Boundary Encroachments
               6.     Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
                      certifies that:
                      a.      the setback/s to any new boundaries for any existing buildings remaining on the site
                              complies with the relevant provisions of the planning scheme and the Building Act
                              1975, unless varied by this Decision Notice;
                      b.      all utility services and connections (e.g., electricity, telecommunications, water,
                              sewerage) are wholly located within the lot they serve or alternatively included within
                              an easement;
                      c.      all existing effluent disposal areas are wholly located within the lot they serve and
                              comply with the boundary setback requirements of the Plumbing and Drainage Act
                              2002 and associated codes and requirements;
                      d.      all dams (including ponded water, dam walls and associated spillway structures) are
                              wholly located within the boundaries of a single lot; and
                      e.      all retaining walls and structures are fully contained within the lot they retain.
                      Services
               7.     Reticulated electricity and telecommunication services must be provided to each lot in
                      accordance with the standards and requirements of the relevant service provider.
               8.     Unless otherwise stipulated by telecommunications legislation at the time of construction, the
                      development must be provided with all necessary conduits, pits and pipes to accommodate
                      the future connection of optic fibre technology telecommunications.
               9.     Certification must be submitted to Council from all relevant service providers (Energex and
                      NBN) which certifies that the development has met the requirements of this Decision Notice
                      and all applicable legislation at the time of construction.
                      Easements
               10.    Unless otherwise agreed in writing by the relevant service provider, any public or third party
                      infrastructure located on the subject site must be placed within an easement registered
                      against the title of the property.




                                                                                                              Page 2 of 5
Document Set ID: 22594835
Version: 2, Version Date: 25/09/2023