Original source · versioned page text
Vehicle_Crossover_FACT_SHEET_PACK_REVISED
From the archive 202300 documents.zip, inside Non-Standard Crossover application - 498 Cooroy Mountain Road Cooroy Mountain. File date in the archive: 2023-02-21 11:43.
Crossover construction requirements: • If excavation will occur as part of the
crossover construction, you must phone
Your crossover must be constructed in Dial before You Dig on 1100 to locate
accordance with the following requirements: underground pipe and cable networks such
• The crossover must not obstruct access or as gas, communications, water and
cause damage to public utilities such as bus electricity. Any damage to infrastructure will
stops, bikeways, parking bays, taxi ranks, be repaired at the property owners’
storm water drains, water meters, fire expense.
hydrants, utility service pits, street trees and
power or light poles.
Crossover guidelines:
• Phone, electrical and Water Meter pits and Council recommends you consider the following
maintenance manholes can be additional steps when constructing a crossover:
incorporated into the crossover with the • Check the condition of all existing kerb,
relevant service provider’s permission. The channel, footpath and road surfaces. Take
service cover is to be adjusted to the level a photograph or provide a written statement
of the crossover at the owners’ expense of all damage and submit it with your
and with the appropriate utility companies application prior to carrying out any work.
consent. Any damage caused by the crossover
• A standard vehicle (i.e. sedan/wagon) must construction will be repaired at the property
be able to negotiate the gradient without owners’ expense.
difficulty or harm to vehicle, pedestrians or • Do not disturb survey marks during
property. crossover construction. They may be
• The crossover drainage must be required for future property boundary
appropriate to ensure your property and identification.
neighboring properties are protected from
storm water overflow in a concentrated Please note – Council, in managing the integrity
form from the road and other properties. of the standard crossover approval process, may
review your construction to ensure you have
• The crossover cross fall must not complied with council’s standards and terms of
direct storm water runoff onto your approval.
neighboring properties.
• Vehicle tracks and other non-constructed Ongoing Obligations:
crossovers are not permitted on the road
reserve (footpath). A full slab crossover As emphasised throughout all of this
must be constructed between the kerb and documentation, the property owner is
the property boundary. responsible for the construction AND
maintenance of a crossover. The crossover is
• Adequate signage, barrier protection and deemed to include any pipe and kerb
redirection measures must be in place if infrastructure which was constructed or altered
construction of the crossover obstructs as part of the crossover construction.
pedestrians or traffic. For standards and
procedures refer to the Manual of Uniform Non-compliance penalties:
Traffic Control Devices at
www.mainroads.qld.gov.au. Failure to comply with the approval conditions
voids the approval thereby making the works
unauthorised and subject to penalties under
section 75 of the Local Government Act (2009).
T (07) 5329 6500 | F (07) 5329 6501 | ABN: 97 969 214 121 | www.noosa.qld.gov.au | [email protected]
Postal address: PO Box 141 Tewantin QLD 4565 | Tewantin office: 9 Pelican Street Tewantin QLD 4565
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalSearchable page text hides email addresses. Original files are unchanged and may show email addresses.