2017-06-06 - P&E Agenda Attachment 1 to Item 6 Draft Alignment Amendments Part 4 (Pages 916-937)

                                                                                                                                     2nd Round Amendments proposed by Council 11 October 2007
     SCHEDULE 1—MINIMUM BOUNDARY SETBACKS FOR




                                                                                                                                                Including amendments to 3 July 2017
                                                                                                                         The Noosa Plan
          BUILDINGS AND OTHER STRUCTURES

1.        Table 1-1 lists Standard minimum boundary setbacks for zones.

          Table 1-2 lists Exceptions for specific premises.

          Table 1-3 lists Exceptions for specific uses.

2.        The minimum boundary setbacks in the tables apply to—
         a)      each building on a premises; and
         b)      structures whether or not located on the same premises as a building.

3.        However, subsection 2 does not apply to—
         a)       class 10a buildings, except in relation to—

                    i        garages and carports in front setback areas;

                    ii       class 10a buildings in the Rural and Rural Settlement Zones;
                                                                1
                    iii      Coastal Protection Precinct setbacks in Table 1-2; or

                    iv    Noosa Waters Estate setbacks in Table 1-2.
         b)       class 10b structures 1m or less in height if—

                    i        a screen or fence 2m or less in height; or

                    ii       rainwater tanks 2.4m or less in height in the Rural and Rural Settlement
                             Zones.
4.       The setbacks in more than 1 table may apply.

5.       If there is a conflict between minimum boundary setbacks in Table 1-1, Table 1-2 or Table
         1-3, the greater boundary setback prevails.

6.       If there is a conflict between the minimum boundary setbacks in Table 1-1, Table 1-2 or
         Table 1-3 and the conditions of an existing development permit affecting the siting of
         buildings on the premises, including an approved building envelope for the premises, the
         conditions prevail.


                                                                     2
Table 1-1—Standard minimum setbacks for Zones
              column 1                                                               Column 2
                Zone                                                             Minimum setbacks
Detached Housing Zone                                      Frontage—6m
                                                           Rear boundary─
                                                                                                         2
                                                           a) where the lot has an area of at least 550m rear
                                                              setbacks comply with either: ─
                                                               i) 3.0m setback up to 4.5m height; and 6.0m
                                                                   setback between 4.5m -8.0m height OR
                                                               ii) no part of the building protrudes beyond a
1
 The Coastal Protection Precinct is shown on the Natural Resource Overlay Maps for certain localities.
2
 If there are no applicable setbacks in either Tables 1-1, 1-2 or 1-3, the siting provisions of Parts 11 and 12 of the
Queensland Development Code apply.



                                                              S1-1