Delegated Report - Code - Planning MCU26 0040, OPW26 0066 & RAL26 0013 (As Published)

                           DEVELOPMENT PERMIT FOR RECONFIGURING A LOT – COMMUNITY TITLE
                                         SUBDIVISION (1 LOT INTO 54 LOTS)
               PLANNING
                      When Conditions Must Be Complied With
               1.     Unless otherwise stated, all works required by the conditions of this Decision Notice must be
                      completed for each particular stage prior to submission of the subdivision plan to Council for
                      compliance assessment.
                      Sunset Clause for Completion of Approved Development
               2.     Pursuant to s88(1) of the Planning Act 2016, the uncompleted aspects of this development
                      approval lapses if the subdivision plan for the last stage of the development has not been
                      registered by the relevant titles authority by 6 August 2032.
                      Approved Plans
               3.     Development authorised by this approval must be undertaken generally in accordance with
                      the Approved Plans listed in the table below.

                           Plan No.              Rev.    Plan/Document Name                               Date

                           04                    I       Site / Floor Plan level 1 – OPT 5 (Staging 26.05.2026
                                                         Plan) prepared by Building Suncoast Green

                      *(Refer to Advisory Note)
               4.     All lot numbering on the subdivision plan to be submitted to Council for compliance
                      assessment must remain as shown on the Approved Plans.
                      Development Staging
               5.     The development may be staged in accordance with the stage boundaries shown on the
                      Approved Plans.
                      Boundary Encroachments
               6.     Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
                      certifies that:
                      a.        the setback/s to any new boundaries for any existing buildings remaining on the site
                                comply with the relevant provisions of the planning scheme and the Building Act 1975,
                                unless varied by this Decision Notice
                      b.        all constructed access and roadworks (including associated fill batters and retaining
                                walls) are fully contained within a dedicated reserve or registered easement
                      c.        all utility services and connections (eg. electricity, telecommunications, water,
                                sewerage) are wholly located within the lot they serve or alternatively included within
                                an easement
                      d.        all existing effluent disposal areas are wholly located within the lot they serve and
                                comply with the boundary setback requirements of the Plumbing and Drainage Act
                                2002 and associated codes and requirements
                      e.        all dams (including ponded water, dam walls and associated spillway structures) are
                                wholly located within the boundaries of a single lot
                      f.        all retaining walls and structures are fully contained within the lot they retain
                      g.        any fill, including fill batters, are wholly contained within the subject site and not on
                                adjacent properties
                      h.        for the community title scheme, the road pavement changes required by this Decision
                                Notice accurately demarcate the boundaries of the public and private land.

                                                                                                            Page 20 of 33

Document Set ID: 25021329
Version: 9, Version Date: 12/08/2026