Council archive · source document
REFERENCE DOCUMENTS - RAL25/0004 (As Published)
Very large file (40.5 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.
Original PDF page 961, section 1. The text section number identifies this passage in the reader.
I1.4 FIELD PROCEDURES
SAMPLING
Samples were collected directly from the sides of each test pit. Nitrile gloves were changed for each
sample collected. Groundwater samples were collected using dedicated disposable bailers.
Samples were taken by hand and placed directly into laboratory supplied containers appropriate for the
analysis. No composite sampling was undertaken.
A fresh set of nitrile gloves were used at each sampling point, with the sampling trowel cleaned between
sampling locations, where used.
TRAVEL/FIELD BLANK
A field blank sample is a solution or appropriate media that is as free as possible of analytes of interest.
The field blank is packaged similarly to the samples being collected, and accompanies the field samples
throughout sampling, transport and laboratory analysis to monitor potential for false positives from
introduced contamination.
Soil trip blanks 051332, 020930, 011745 and 011747 were used as part of the current assessment and
analysed for TRH(C6-C9) and BTEXN with 020930 further analysed for PFAS, which were not detected.
Groundwater trip blank 220817 was analysed for TRH(C6-C9) and BTEXN which were not detected.
RINSATE
A rinsate sample is a solution that is as free as possible of analytes of interest, used to rinse
decontaminated reusable field equipment. Exposed rinsate is collected after contact with the
decontaminated sampling equipment and analysed to monitor potential for false positives from residual
contamination. Due to limited use of reusable sampling equipment, a rinsate sample was not collected.
DOCUMENTATION
Field QC included sample transportation under Chain of Custody procedures. Completed Chain of
Custody documentation and Sample Receipt Advice forms, certifying the condition of the samples upon
arrival at the contract laboratory, are attached with the ALS and Envirolab laboratory reports.
STORAGE AND TRANSPORT
Samples were collected into laboratory supplied containers appropriate for the matrix and the proposed
analysis and stored in ice-cooled and insulated containers. Sample integrity was maintained by using
sealed glass jars (soil samples) plastic bags (asbestos testing only) or dedicated glass or plastic water
sample containers.
FIELD DUPLICATES
A field duplicate is a single sample that is split into two sample containers with both separately analysed
by the primary or secondary laboratory (with unrelated sample labelling), providing a measure of
analytical precision. The results of both samples are then assessed by comparing the Relative
Percentage Difference (RPD) of each analyte, noting that the RPD may also be influenced by sample
heterogeneity and sampling procedures.
𝑉1−𝑉2
Relative Percentage Difference (RPD) = 𝑉1+𝑉2 𝑥 100
( )
2
The generally adopted RPD criteria is 30% RPD for field duplicates for inorganics and 50% RPD for
field duplicates for organics.
125 Lot 105 SP118458 Cooroy DSI 12062024 Rev0 Lot 105 SP118458, Cooroy, QLD, 4563
12/06/2024 95 Detailed Site Contamination Investigation
Document Set ID: 23717062
Version: 0, Version Date: 01/01/1900
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
REFERENCE DOCUMENTS - RAL25/0004 (As Published)Related documentApplication case desk ↗
About this file
- File size
- 40.5 MB (very large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.