Skip to the record
Trusted by locals. Built for Noosa.

Council archive · source document

Attachment 2 - Construction and Tree Management Plan · OPW25/0206

of 40

Check the original when the exact wording matters.

Plans and drawings: the text below has words only, no drawings.

Log in to see the plans as drawn
4 T REE P ROTEC TION F ENCING
Due to the nature of the RACV Noosa site, standard Tree Protection Fencing (TPF) will not be
achievable throughout the site. The typical steel mesh panels are not suitable to create the
Exclusion Zones internally but may be used for site perimeter fencing that can be incorporated
into the tree Exclusion Zone setout.

Exclusion Zone fencing is to consist of 1m high fabric orange mesh barrier fencing with star
pickets with end caps as support, spaced at 4 – 5m and attached with zip ties in a fauna-friendly
manner. Flagging is to be used on areas away from the site to demarcate 'no-go zones'. The
photographs below show alternative options that are considered suitable.

When the access and construction requirements have been established, the exclusion zones can
be positioned for the trees to be retained and the alignment of the TPF can be determined. The
TPF is required to be installed in the presence and under the guidance of the Project Arborist prior
to any construction works commencing on the site and should remain intact until the completion
of all works.

As the entire site is considered a protected zone the TPF will be erected in a non-standard
alignment with additional measures installed. Ground protection is to be installed specific to
requirements.

Trunk and branch protection, to prevent direct contact with the tree’s branch, trunk and/or buttress
roots should be installed. This can comprise Geo fab or 20mm thick hessian and wooden battens
strapped/taped to the tree’s trunk with a skirt over the buttress roots.

These protection measures will be established between the construction company and the Project
Arborist.

4.1 RESTRICTED ACTIVITIES WITHIN THE EXCLUSION ZONES
Restricted activities within the Exclusion Zones that would cause harm to the retained trees
include, but are not limited to:

   •   Any non-approved construction works.
   •   Any non-approved excavation or cultivation of the ground.
   •   Any non-approved storage.
   •   Preparation of chemicals, including cement products.
   •   Parking of vehicles and plants.
   •   Refuelling.
   •   Dumping of waste.
   •   Wash down and cleaning of equipment.
   •   Placement of Fill.
   •   Lighting fires.
   •   Any non-approved soil level changes.
   •   Temporary or permanent installation of utilities and signs.
   •   Physical damage to the tree.



24_11_22_RACV Noosa_Tree Protection Procedures                                           Page 7 of 11

Used in these records

About this file

File size
9.9 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Attachment 2 - Construction and Tree Management Plan.pdf · 9.9 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.