Decision Notice OPW14-0120 32 Saltwater Ave Noosaville · OPW14/0120

                                                                              OPW14/0120

4.    No posts or vertical supports of the proposed jetty are to extend vertically from the
      structure unless they provide support for the handrail.

5.    No boatlifting devices are to be attached or moored at the jetty structure for the
      purpose of elevating a vessel above the water without Council approval.

6.    There must be no electrical reticulation system carrying electricity in excess of 24
      volts beyond the revetment wall unless all switches and power outlets are
      positioned above the 1%AEP flood level.

7.    Lighting associated with the use must be designed, installed, operated, and
      maintained in accordance with Section 3 of AS4282 Control of the Obtrusive
      Effects of Outdoor Lighting.

8.    Rock scour protection, wrapped in geotextile, extends 3000 mm from the face of
      the revetment wall in this locality. Prior to driving piles, the rocks are to be
      removed to expose the geotextile and the geotextile cut neatly to allow it to be
      turned back. During pile driving, care is to be taken to ensure the geotextile is not
      damaged. At the completion of pile driving, the fabric is to be turned down around
      the pile and the rocks replaced around the piles.

9.    The jetty is to be used for private purposes only with no commercial operations to
      be undertaken.

10.   Boat repair activities are not permitted on site.

11.   Wastewater and sullage must only be disposed of at approved pumpout facilities.

12.   The mooring facility must not be utilised for live-aboard purposes.

13.   Any construction and post construction activity is not to impact on the condition of
      the waterway, and is to be conducted so as not to breach the Environmental
      Protection Act EPA (1994) and the Environmental Protection (Water) Policy 2009.

14.   The approval or conditions do not constitute a ruling on structural safety and the
      applicant must make their own arrangement to ensure adequacy of design and
      work. Also any approval granted does not warrant that such plans and
      specifications have been checked in detail, nor does it absolve the owner of the
      land from complying with all the conditions of this approval and/or relevant Council
      By-Laws and Policies and/or relevant statues and/or statutory regulations in the
      execution and/or performance of said works. Council does not accept any
      responsibility for the accuracy of such plans and specifications as approved.

15.   Certification by a Registered Professional Engineer of Queensland that states that
      the jetty is constructed in accordance with best practice methods and is structurally
      sound must be submitted to Council. A final inspection and approval of the
      structure by Council’s Inspector is also required. Please contact Council’s
      Planning Assessment Section (Development Audit & Response Officer
      0428738563) to arrange the inspection.

16.   This approval lapses where the construction of the jetty has not commenced within
      two (2) years of the date of issue of the approval, unless application is made and
      approved by Council for an extension.

17.   After completion, the proposed works must be maintained in a sound state of
      repair in accordance with the approved plans




                                                                                    Page 2 of 6