Skip to the record
Noosa's #1 Council Tracker.

Council archive · source document

Referral Agency Response - Planning RAP20 0009 · RAP20/0009

of 1

Text shows just the words. Original shows the document exactly as it was published.

Officer: 	Glen Conforti
Direct Telephone: 	07 53296241
Our Reference:	RAP20/0009
Your Reference:	n/a
25 June 2020
Project BA
PO Box 45
NOOSAVILLE QLD 4566
[email protected]
Dear Sir
Referral Agency Response
Planning Act 2016
I refer to your application and advise that Council, as a concurrence agency for the application, completed its assessment of the application on 24 June 2020. You are advised that Council requires conditions to be attached to any development approval. The conditions are listed below.
application details
Application No:	RAP20/0009
Street address:	6 Wildflower St Sunshine Beach Qld 4567
Real property description:	Lot 81 RP 94566
Planning Scheme:	The Noosa Plan (8 June 2018)
type of development
The applicant seeks the following type of development approval:
Development Permit for Building Works (Detached House)
concurrence agency conditions
PLANNING
When Conditions must be Complied With
Unless otherwise stated, all conditions of this Decision Notice must be complied with prior to the use commencing, and then compliance maintained at all times while the use continues.
Approved Plans
Development undertaken in accordance with this approval must generally comply with the approved plans of development. The approved plans are listed in the following table unless otherwise amended by these conditions.

Plan No.	Rev.	Plan/Document Name	Date
SD02	2P5	Site Plan, Caldicott Designs	21/05/20
SD05	2P5	Ground Floor Plan, Caldicott Designs	21/05/20
SD06	2P5	Upper Floor, Caldicott Designs	21/05/20
SD07	2P5	Roof Terrace, Caldicott Designs	21/05/20
SD08	2P5	East Elevation, Caldicott Designs	21/05/20
SD09	2P5	West Elevation, Caldicott Designs	21/05/20
SD10	2P5	N & S Elevation, Caldicott Designs	21/05/20
SD11	2P5	Aerial View From NE Corner, Caldicott Designs	21/05/20
SD12	2P5	Aerial View From SE Corner, Caldicott Designs	21/05/20
Job No: 19-0284 Dwg No: C03	0	Ground Floor SW Drainage Layout,  prepared by HR Design Consulting Engineers	04/07/2019
Building Height
The maximum height of the development must not exceed 8 metres above the finished ground level and the natural ground surface except to the south west corner of the upper floor roof which must not exceed 8.4m above the NGL.
Certification must be submitted to Council from a Licensed Surveyor which certifies that the building does not exceed the maximum height requirement of this Decision Notice.
Building design
The garage wall must comply with Queensland Development Code requirements.
The landing and stairs associated with the garage (to the south) must not exceed 0.5m above the NGL. However, these structures may be incorporated into a garage wall which is compliant with the Queensland Development Code.
The gatehouse must comply with Queensland Development Code requirements.
The drying court FFL must not exceed 0.5m above NGL within the 1.5m boundary setback.
Privacy
Bedroom 4 windows must include fixed external screens, positioned in such a way to obscure direct views into the habitable room windows or private open space areas of the adjoining properties.
Roof terrace
The screening device along the western side of the roof terrace and the roof terrace balustrade must be setback a minimum of 6m from the rear boundary.
The roof terrace must not be roofed except for the eave indicated on the approved plans.
The roof terrace must not be enclosed.
Sunset clause
This Concurrence Agency response is no longer valid if the use has not commenced within 4 years of the date of this notice, unless otherwise extended in writing by Council.
Performance Bond
Security in the form of a cash bond or trading bank guarantee to the sum of $5,000 must be submitted to Council, to secure performance of all conditions of this approval, prior to the issue of a Development Permit for Building Works. The cash bond or trading bank guarantee will be returned on performance of the conditions of approval less any costs incurred by Council in respect of enforcing performance of this permit. Council reserves the right to call upon the bond or guaranteed sum to effect compliance with conditions.
Landscaping
Existing trees in the road reserve must be retained, unless written authorisation from Council is granted for their removal.
Trees to be retained must be protected from clearing or construction activities by:
clearly marking vegetation to be retained with flagging tape
installing protective fencing around the drip line of the vegetation
restricting stockpiling, storage and vehicle parking to those areas which are already cleared
using low impact construction techniques around vegetation.
A minimum of 20% of the site must be retained as soft landscaping. All landscaping must be in accordance with Council’s Planning Scheme Policy PSP3 Landscaping Plants and Guidelines. All trees required to be planted by this Decision notice must have a minimum pot size of 200mm.
A 0.75m wide garden must be provided adjacent to and for the full length of the laundry landing and stairs. One native endemic 1 tree with a mature height of no less than 8m must be planted within this garden.
Trees must be planted in the following locations:
One tree in the south west corner of the site which must grow to a minimum height of 8m;
Two trees evenly space adjacent to the kitchen along the eastern boundary. One tree must be located opposite the kitchen northern window. The trees must grow to a minimum height of 8m;
One tree opposite the family room eastern window. The tree must grow to a minimum height of 6m.
One tree centrally located between the two living room 1 windows (ground floor) along the western boundary. The tree must grow to a minimum of 6m.
Earthworks
Earthworks required on site must be carried out in accordance with Council’s Planning Scheme Policy PSP5 Engineering Design Standards, so as not to cause the additional ponding of water on any adjoining lands or concentrate or direct overland flow on to an adjoining property.

Stormwater Drainage
The stormwater drainage works for the development site must be carried out generally  in accordance with the engineering plan titled Ground Floor SW Drainage Layout,  prepared by HR Design Consulting Engineers Ref Job No: 19-0284, Dwg No: C03 dated 04/07/2019; and must comply with the following:
Providing all reasonable measures (including provision of stormwater detention and harvesting tanks) to prevent and/or minimise adverse stormwater discharge onto other properties and maintaining runoff from the site to its predevelopment rates for all storm events up and including 1% AEP event.
The stormwater drainage works on site must be supervised and certified by a suitably qualified RPEQ. The certification of the completed works must be submitted to Council prior to obtaining the final Building Certification.
Erosion and Sediment Control
Sediment and erosion control measures must be in place prior to works commencing. If such measures are not in place or are not satisfactory, “on the spot” fines may be issued. Such fines can be issued if sediments from the site are found to enter or have the potential to enter Council’s stormwater system, natural waterways, any downstream stormwater filtration system or adversely impacting on other properties.  The sediment and erosion control design and measures have NOT been approved, it is the site's Supervising Engineer who is responsible for ensuring that the sediment and erosion control measures have:
Been duly designed by an RPEQ or CPESC and constructed in accordance with "best practise" methods,
Been revised by an RPEQ or CPESC to address the issues raised by changes in the projected construction schedule and/or methods,
Been revised to address predicted rainfall events, and
Achieve the desired environmental outcomes.
Council may request further controls to be installed should the implemented measures be found inefficient.
The erosion and sediment control measures must be designed, installed and maintained in accordance with the supervising engineer instructions and the current best practice standards * (Refer to Advisory Note).
The developer must ensure non-essential exposure of soil is prevented by restricting the extent of disturbance and minimising the duration of soil exposure to adverse weather conditions and effectively turf, cover or stabilise any disturbed area without delay and prior to rainfall occurring.
The developer must ensure sediment does not leave the site or enter onto adjoining properties or Council’s drainage system due to surface runoff or on tyres of vehicles and/or machinery. It is essential to implement appropriate approved erosion and sediment control measures throughout the site during all phases of construction including vehicle shakedown pad/grid (or similar) at the access to the construction site and siltation and sediment basin/s. Where sediments or other contaminants are deposited on a road, they must be removed so as not to enter Council’s drainage system or waterways.
Prior to the completion of the development and commencement of use, all site surfaces must be effectively stabilised using methods which have achieved effective short-term stabilisation and which will continue to achieve effective stabilisation in the medium to long-term. For the purpose of this condition, an effectively stabilised surface is defined as one that does not, or is not likely to result in visible evidence of soil loss caused by sheet, rill or gully erosion or lead to sedimentation, or lead to water contamination.
reasons for inclusion of conditions
The proposal is subject to specific built form parameters outlined in The Noosa Plan.
Advisory notes
The following notes are included for guidance and information purposes only and do not form part of the referral agency conditions:
Property Driveway and Vehicle Crossover
The planning scheme declares Operational Work for the construction of a driveway and vehicle crossover to the property to be self-assessable against the Detached House Driveways Code. A self-assessable application is required to be submitted to Council for the vehicle crossover (*link below) OR if the proposed driveway and vehicle crossover does not comply with each Acceptable Solution contained in the Code, a Development Permit for the work is required to be obtained from Council.
*http://www.noosa.qld.gov.au/documents/40217326/40415739/Vehicle%20Crossover%20Application%20Pack.pdf
Sustainability
In line with Noosa Council’s Corporate Plan, Council seeks to encourage sustainable building design for residential and commercial development. Council encourages the use of sustainable building materials, energy efficient fittings, solar hot water, photovoltaic systems (including the use of inverter/charges), water saving devices and rainwater harvesting. For further information go to http://www.noosa.qld.gov.au/sustainable-homes
Erosion and Sediment Control
Accepted best practice standards include:
the Sunshine Coast Regional Council Manual for Erosion and Sediment Control V1.2 or other superseding document subsequently adopted by Council;
Best Practice Erosion and Sediment Control, International Erosion Control Association (2008)
rEPRESENTATIONS ABOUT REFERRAL AGENCY RESPONSE
The applicant may make representations to Council about this referral agency response at any time before the application is decided pursuant to section 30 of the Development Assessment Rules.

Yours faithfully,

Glen Conforti
Development Planner

Enc:	Approved Plans/Documents

[word/footer2.xml]
Page 2 of 5

[word/footer3.xml]
PO Box 141		P. (07) 5329 6500	[email protected]	
	TEWANTIN  QLD  4565	F. (07) 5329 6501	www.noosa.qld.gov.au
				Page 1 of 5

[word/header1.xml]
3

Used in these records

About this file

File size
78 KB (small file)
File type
DOCX

No other editions are linked here.

Original file

Log in to download the original file

Referral Agency Response - Planning RAP20 0009.docx · 78 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.